7 Edit the phone number if necessary (24
digits max.). a
2 times
Erasing an outside monitoring
number
1 Press
on the handset being
monitored.
2 MbN: “On/Off” a
3 MbN: “On” a
4 MbN: Select the outside line. a
5 a MbN: “Erase” a
6 MbN: “Yes” a
Baby monitor sensitivity
You can adjust the sensitivity of the baby
monitor. Increase or decrease the sensitivity to
adjust the sound level needed to trigger the
baby monitor feature.
R This feature cannot be set during a
monitoring call.
1 Press
on the handset being
monitored.
2 MbN: “Sensitivity Level” a
3 Press MDN or MCN to select the desired
setting. a
a M N
Note:
R When the baby monitor is activated, you
cannot access the direct commands using
the monitored handset. Before setting the
baby monitor feature, you can use direct
commands to adjust baby monitor
sensitivity (page 32).
Answering the baby monitor
n When monitoring with a handset:
Press M N to answer calls.
If you want to respond from the monitoring
handset, press
.
R The monitoring handset will answer calls
automatically when the auto intercom
feature is set to “On” (page 53).
Note:
R If you receive an outside call when
communicating with the monitored
handset, you hear 2 tones. To answer
the call, press M N, then press M N.
n When monitoring from an outside line:
To answer a call, follow the operation for
your phone.
If you want to respond from the monitoring
handset, press #1 using tone dialling.
You can turn off the baby monitor feature
by pressing #0.
Note:
R 2 minutes after the monitored handset
starts a call, communication between the
monitored handset and monitoring
phone line is turned off automatically.
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to a single
base unit.
Important:
R The additional handset model
recommended for use with this unit is noted
on page 4. If another handset model is
used, certain operations (handset settings,
base unit settings, etc.) may not be
available.
Additional base units
Handsets can be registered to up to 4 base
units, allowing you to add additional base units
and extend the area in which your handset(s)
can be used. If a handset moves out of range
of its base unit when “Auto” is selected on
base unit (page 40), it looks for another
base unit to make or receive calls. A base unit
and the handsets it communicates with is
called a “radio cell”.
39
Programming
