Bedienungsanleitung Panasonic KX-TGA100N (Seite 3 von 4) (Englisch)

628752

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

3-E Helpful Information

CAUTION:

To reduce the risk of fire or injury to persons, read and follow these instructions.

1.Use only the battery(ies) specified.

2.Do not dispose of the battery(ies) in a fire. They may explode. Check with local

waste management codes for special disposal instructions.

3.Do not open or mutilate the battery(ies). Released electrolyte is corrosive and may

cause burns or injury to the eyes or skin. The electrolyte may be toxic if swallowed.

4.Exercise care in handling batteries in order not to short the battery to conductive

materials such as rings, bracelets, and keys. The battery and/or conductor may

overheat and cause burns.

5.Charge the battery(ies) provided with or identified for use with this product only in

accordance with the instructions and limitations specified in this manual.

WARNING:

TO PREVENT FIRE OF SHOCK HAZARD, DO NOT EXPOSE THIS

PRODUCT TO RAIN OR ANY TYPE OF MOISTURE.

FCC and Other Information

When programming emergency numbers and/or making test calls to emergency

numbers:

1. Remain on the line and briefly explain to the dispatcher the reason for the call

before hanging up.

2. Perform such activities in the off-peak hours, such as early morning hours or late

evenings.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) This device may not cause harmful interference, and (2)

this device must accept any interference received, including interference that may

cause undesired operation.

Privacy of communications may not be ensured when using this phone.

CAUTION:

Any changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate this device.

Note:

This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

— Reorient or relocate the receiving antenna.

— Increase the separation between the equipment and receiver.

— Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

— Consult the dealer or an experienced radio/TV technician for help.

Some cordless telephones operate at frequencies that may cause interference to

nearby TVs and VCRs. To minimize or prevent such interference, the base of the

cordless telephone should not be placed near or on top of a TV or VCR. If interference

is experienced, move the cordless telephone further away from the TV or VCR. This

will often reduce, or eliminate, interference.

Operating near 2.4GHz electrical appliances may cause interference. Move away from

the electrical appliances.

CAUTION:

To comply with FCC RF exposure requirements, the handset should be carried with

the specific belt-clip provided for the handset to ensure compliance. Other non-tested

belt-clips or similar body-worn accessories may not comply, therefore, should be

avoided.

After charging the handset,

the display will show the

following.

Enter the 15-digit Base

Unit ID code located on

the bottom of the base

unit.

•If you misdial, press .

Digits are erased from the right.

Press .

•A beep sounds and “PLEASE

WAIT!!” is displayed.

)

(

)

(

Wait until a beep sounds on the

handset and base unit.

•After a few seconds, the handset

number (1 to 4) will be displayed.

•If “BASE BUSY TRY LATER” is

displayed in step 4, the unit is in use.

Wait until the unit is in the standby

mode, and repeat steps from 2.

•If “ENTER BASE ID” is displayed in

step 3, you entered a wrong Base ID

code. Enter the correct code.

Registration is necessary for cordless handsets. An handset will be assigned the

number at registration. The number is used as the handset number. You can register

up to 4 handsets at the KX-TG1000N base unit.

Make sure the unit is in the standby mode initially.

ENTER BASE ID

###############

HANDSET 2

RDL MEMMENU

PLEASE

WAIT!!

SEARCHING

FOR BASE

NEW MENU

•Recharge the battery when:

—“LOW BATTERY” is displayed, or

—“ ” flashes on the display.

Battery information

After your Panasonic battery is fully charged:

∗In case the Range Extender Mode is set to “OFF”, see page 48 in the English

operating instructions.

•

Battery life may be shortened depending on usage conditions and ambient temperature.

•Clean the charge contacts of the handset and the charger with a soft, dry cloth

once a month. Clean more often if the unit is subject to grease, dust or high

humidity. Otherwise the battery may not charge properly.

•The battery cannot be overcharged.

Charging the battery

Place the handset on the charger and charge for about 12 hours

before initial use.

During charging the battery, the battery

icon cycles as shown below.

Up to 5.5 days

Operation

Approx. battery life

While in use (TALK)

Up to 10 hours*

While not in use (Standby)

1-D Battery

Getting Started

Things You Should Know

Registration

Section 1 Section 2

Section 3

rge

tacts

FOUND

BASE

RDL MEMMENU

Panasonic KX-TGA100N Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info