You can configure this setting using either the
base unit or one of the handsets.
Handset / Base unit
1 For MOBILE 1: MMENUN#6031
For MOBILE 2: MMENUN#6032
2 MbN: Select the desired setting. a
MSAVEN
3 Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Selecting the alert tone
Handset
1 For MOBILE 1: MMENUN#6041
For MOBILE 2: MMENUN#6042
2 MbN: Select the desired setting.
3 MSAVEN a MOFFN
Temporary alert off
You can temporarily disable the alerts by
pressing MAPP ALERTSN.
Base unit
Press MAPP ALERTSN to temporarily disable
alerts.
R
is displayed.
R To enable alerts again, press MAPP
ALERTSN again.
Using a Bluetooth wireless
headset (optional) for
landline calls
By pairing a Bluetooth headset to the base
unit, you can have a hands-free conversation
wirelessly for landline calls.
Important:
R Your Bluetooth wireless headset must
support the HeadSet Profile (HSP)
specification.
R 1 headset can be paired to the base unit.
R Only 2 Bluetooth devices can be used with
the unit at the same time (for example, 2
mobile lines, or the headset and 1 mobile
line).
R For best performance, we recommend
using a Bluetooth headset within 1 m of the
base unit. A headset can communicate with
the base unit within a range of
approximately 10 m.
Pairing a headset to the base unit
Important:
R Make sure that the Bluetooth headset is not
connected to any other Bluetooth device.
1 Your headset:
Set your headset to pairing mode.
R Refer to the headset operating
instructions.
2 Handset:
MMENUN#621
3 If your headset PIN is “0000”, go to
step 4.
If your headset PIN is other than
“0000”, press MCLEARN, then enter your
headset PIN.
R Typically, default PIN is “0000”. Refer
to the headset operating instructions.
4 Press MOKN, then wait until a long beep
sounds.
5 MOFFN
R When
is displayed on the base
unit, the headset is available for use.
Connecting/disconnecting a headset
If you cannot connect the headset and base
unit using the headset, you can connect using
the handset.
To use your headset with another Bluetooth
device such as a mobile phone, you may need
to disconnect it from the base unit.
Important:
R Make sure that the headset is turned on.
Handset
1 To connect/disconnect:
MMENUN#622
R A long beep sounds.
2 MOFFN
59
Using Bluetooth® Devices
