Bedienungsanleitung Panasonic KXTCD440 (Seite 34 von 40) (Englisch)

39160

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

34 Helpline Tel. No. :U.K. 08700 100 076 R.O.I. 01289 8333

Useful Information

Useful Infor mation

Troubleshooting

If you still have difficulties after following the

instructions in this section, disconnect the

AC adaptor and turn off the handset, then

reconnect the AC adaptor and turn on the

handset.

0w4 is flashing.

L The handset is not registered to the base

unit. Register it (page 30).

L The handset is too far from the base unit.

Move closer.

L The AC adaptor is not connected. Check

the connections.

I cannot make or receive calls.

L The AC adaptor or telephone line cord is

not connected. Check the connections.

L If you are using a splitter to connect the

unit, remove the splitter and connect the

unit to the wall socket directly. If the unit

operates properly, check the splitter.

L Disconnect the base unit from the

telephone line and connect the line to a

known working telephone. If the working

telephone operates properly, contact our

service personnel to have the unit

repaired. If the working telephone does

not operate properly, contact your service

provider.

L The call bar feature is turned on. Turn it off

(page 20).

L You dialled a call restricted number

(page 23).

L The key lock feature is on. Turn it off

(page 11).

The unit does not ring.

L The ringer volume is turned off. Adjust the

handset ringer volume (page 18) and the

base unit ringer volume (page 22).

The handset display is blank.

L The handset is not turned on. Turn the

power on (page 8).

The handset will not turn on.

L Make sure that the batteries are installed

correctly (page 6).

L Fully charge the batteries (page 7).

L Clean the charge contacts and charge

again (page 7).

The battery should be charging but the

battery icon does not change.

L Clean the charge contacts and charge

again (page 7).

L The AC adaptor is disconnected. Plug in

the AC adaptor.

A busy tone is heard when {C} or {s} is

pressed.

L The handset is too far from the base unit.

Move closer and try again.

L Another handset is on an outside call.

Wait for the other user to complete the

call.

Static, sound cuts in/out, fades.

Interference from other electrical units.

L Locate the handset and the base unit

away from other electrical appliances.

L Move closer to the base unit.

The handset stops working while being

used.

L Disconnect the AC adaptor and turn off

the handset. Connect the AC adaptor, turn

on the handset and try again.

While storing an entry in the phonebook

or assigning a hot key, the handset starts

to ring.

L A call is being received. To answer the

call, press {C} or {s}. Programming will

be cancelled. Start again.

Pressing {R} does not display/dial the

last number dialled.

L If the redialled number was more than

24 digits long, the number will not be

TCD440_445E.book Page 34 Friday, February 27, 2004 4:22 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic KXTCD440 Seite 34

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info