Bedienungsanleitung Panasonic NA-148XS1 (Seite 17 von 24) (Englisch)

575327

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

32 3333

Troubleshooting

Problem Cause and Measures

Appliance

Buttons do not

work

- Settings cannot be changed while an operation is in

progress. Only the spin speed, “Extra Rinse” and “Easy

Iron” settings can be changed when the wash process

is paused.

- The Child Lock (

) may be activated. (P. 28)

Door does not

open

- The door is locked while an operation is in progress.

(P. 14)

- The Child Lock (

) may be activated. (P. 28)

- The temperature inside the drum may be very high.

- The water level may be too high.

■ To open the door immediately

(1) Switch the appliance off and then on again.

(P. 10)

(2) Select the “Cotton” programme.

(3) Select

in “Mode” (P. 26), and start operation.

- If you switch off the appliance or there is a power cut

while the door is locked, it remains locked until the

power is turned on again.

Unusual odour

- Rubber parts may give off a smell when you rst use

the appliance, but the smell will go away over time.

- Run a wash at 60 °C to clean the drum. (P. 30)

Wash

No water going

into the appliance

- The tap may be turned off.

- The water supply may be disrupted.

- The water supply hose may be frozen. (P. 29)

- The water supply lter may be blocked. (P. 29)

Water builds up

during a wash

- This is normal. Water is automatically supplied if the

water level falls.

Water drains out

during a wash

- If there is excess foam, water is drained out and fresh

water supplied to remove the foam. This is the foam

detection function.

- Even if water is directly supplied to the drum, it may

drain away without building up.

Water supply

stops and water is

drained away

- The water supply is automatically stopped if the water

volume in the drum reaches a certain level, and some

water may drain away. This feature is called the

overow detection function.

Troubleshooting

Opening the Door in an Emergency

When the door stays locked due to

a power failure, or while displaying

an error that starts with “H”, the door

can be opened using the following

instructions.

1 Turn off the power, and open the

drain lter cover. (P. 31)

2 When there is water in the drum,

drain the water by removing the

drain lter. (P. 31)

3 Pull down the emergency door

unlock tab.

The door lock is released, and you

can open the door.

Emergency

door unlock tab

CAUTION

zThere is a risk of burns during

operation at high temperatures.

- Operate after temperature has

fallen.

zThere is a risk of injury if you put

your hand in the drum during

rotation.

- Operate after the rotation has

stopped.

zOpening the door when water

can be seen through the glass of

the door may cause the water to

spill.

- Drain the water by removing the

drain lter. (P. 31)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic NA-148XS1 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Panasonic NA-148XS1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info