Bedienungsanleitung Panasonic NN-SD26HM (Seite 8 von 54) (Englisch)

734702

Zoom out

Zoom in

Vorherige Seite

1/54

Nächste Seite

Read carefully and keep for future

reference.

This appliance is supplied with a moulded

three pin mains plug for your safety and

convenience, which may be marked, and

rated 10 amps.

A 10 amp fuse is tted according to the type

of mains plug tted.

Should the fuse need to be replaced, please

ensure that the replacement fuse has the

correct rating for the type of mains plug

tted and that it is approved by ASTA

or BSI to BSI362.

Check for the ASTA mark or the BSI

mark on the body of the fuse.

Warning!

If the fuse cover is detachable,

never use the plug with the cover

omitted. A replacement fuse cover

can be purchased from your local

Panasonic Dealer.

How to replace the fuse

Open the fuse

compartment with

a screwdriver and

replace the fuse.

If the tted moulded plug is unsuitable

for the socket outlet in your home then

the fuse should be removed and the plug

cut off and disposed of safely and an

appropriate one tted. There is a danger

of severe electrical shock if the cut off

plug is inserted into any 10 amp socket.

If a new plug is to be tted, please observe

the wiring code as shown opposite. If in any

doubt, please consult a qualied electrician

(For U.K. Models only).

Warning!

This appliance must be earthed.

Important!

The wires in this mains lead are

coloured in accordance with

the following code: Green-and-

yellow: Earth. Blue: Neutral.

Brown: Live.

As the colours of the wire in the mains

lead of this appliance may not correspond

with the coloured markings identifying the

terminals in your plug, proceed as follows:

The wire which is coloured green-and-

yellow must be connected to the terminal in

the plug which is marked with the letter E or

by the Earth symbol or coloured green

or green-and-yellow.

The wire which is coloured blue must be

connected to the terminal in the plug which

is marked with the letter N or coloured

black.

The wire which is coloured brown must be

connected to the terminal in the plug which

is marked with the letter L or coloured red.

When this oven is installed it should be easy

to isolate the appliance from the electricity

supply by pulling out the plug or operating a

circuit breaker.

Voltage & Power

The voltage used must be the same

as specied on this microwave oven.

Using a higher voltage than that

which is specied is dangerous and

may result in a re or other type of

accident causing damage.

Do not immerse cord, plug or oven in water.

Keep cord away from heated surfaces. Do not

let cord hang over the edge of table or work

top. Do not plug your oven in via an extension

cable as this can be dangerous. It is important

to plug the oven directly into a wall socket.

The back of the appliance heats up during

use. Do not allow the cord to be in contact

with the back of the appliance or cabinet

surface.

Safety Instructions

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic NN-SD26HM Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info