60
≥The Time Code cannot be reset to zero.
≥Unless the Time Code is continuously recorded
from the beginning of a tape, accurate editing
may not be possible. To ensure that the Time
Code will be recorded with no breaks, we
recommend the use of the Blank Search
Function (l 34) before recording a new scene.
ª Memory Stop Function
The Memory Stop Function is useful for the
following operations.
Rewinding or fast-forwarding a tape to a
desired position
1 Set [DISPLAY SETUP] >> [C.DISPLAY]
>> [MEMORY].
2 Reset the Tape Counter to zero at the
tape position from which you want to
play it back later. (l 10, 17)
3 Start playback or recording.
4 After playback or recording has
finished:
Set the [VCR/OFF/CAMERA/M-CARD]
Switch to [VCR].
5 Rewind the tape.
≥The tape automatically stops approximately
at the position where the counter was set to
zero.
Stopping editing automatically during audio
dubbing
1 Set [DISPLAY SETUP] >> [C.DISPLAY]
>> [MEMORY].
2 Reset the Tape Counter to zero at the
position where you want to stop
editing.
3 Play back the still picture where you
want to start audio dubbing.
4 Start audio dubbing. (l 37)
≥Audio dubbing automatically stops at the
position where the counter was set to zero.
ª Owner ID
You can register your name and address in your
Movie Camera to identify the owner.
1 Set [CAMERA FUNCTIONS] >>
[OTHER FUNCTIONS] >>
[OWNER ID SET] >> [ON].
≥The [OWNER ID] Menu appears.
2 Turn the [PUSH] Dial to select
[PIN NUMBER] and press the [PUSH]
Dial to input desired numbers.
3 Turn the [PUSH] Dial to select
numbers and press the [PUSH] Dial to
enter them.
≥You can input 4 digits.
4 Press the [∫] Button.
5 Repeat Steps 2–4 to input desired
characters for [NAME] and
[POSTCODE].
≥You can input up to 12 characters in
[NAME], and up to 11 characters in
[POSTCODE].
6 Press the [∫] Button to finish the
setup.
To verify Owner ID
≥Keep pressing the [;] Button for approximately
5 seconds.
To Check Owner ID
If Owner ID has already been set, carrying out
Step 1 above will display [INPUT PIN NUMBER]
on the screen. Input the Pin Number you have
already selected. If the number is not correct, the
screen will not change. If the number is correct,
the contents of the setup will be displayed. (By
repeating Steps 2 to 4 above, you can change the
contents.)
ª Demonstration Mode
If no operation takes place for approximately
10 minutes after the AC Adaptor was connected to
the Movie Camera and the [VCR/OFF/CAMERA/
M-CARD] Switch was turned to [CAMERA]
without inserting a Cassette, the Movie Camera is
automatically set to Demonstration Mode for
introducing its functions. If any button is pressed
or operated, the Demonstration Mode is
cancelled. The Demonstration Mode can be
started by setting [DEMO MODE] on the
[OTHER FUNCTIONS] Sub-Menu of the
[CAMERA FUNCTIONS] Main-Menu to [ON] and
by exiting the Menu. To terminate the
Demonstration Mode, insert a Cassette or set the
[DEMO MODE] to [OFF].
B-Eng.book 60 ページ ２００３年２月１４日 金曜日 午後２時４３分
