Bedienungsanleitung Panasonic NVDS38B (Seite 45 von 52) (Englisch)

627275

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

erase the contents of a recording or may cause noise in

images and sounds.

Card (NV-DS37/DS38 only)

≥When the Card is being read, do not remove the Card, turn

off the power, or subject it to vibration or impact.

≥Do not leave the Card in places where there is high

temperature or direct sunlight, or where electromagnetic

waves or static electricity are easily generated.

≥Do not bend or drop the Card. The Card or the recorded

content may be damaged.

≥After use, be sure to remove the Card from the Movie

Camera.

≥Do not touch the terminals on the back of the Card with

your fingers. Do not allow dirt, dust or water to enter it.

ª LCD Monitor/Viewfinder/Lens Hood

LCD Monitor

≥In a place with drastic temperature changes, condensation

may form on the LCD Monitor. Wipe it with soft dry cloth.

≥If your Movie Camera is extremely cold when you turn its

power on, the image on the LCD Monitor is slightly darker

than usual at first. However, as the internal temperature

increases, it goes back to the normal brightness.

..............................................................................................

Extremely high precision technology is employed to produce

the LCD Monitor screen featuring a total of approximately

110,000 pixels. The result is more than 99.99% effective

pixels with a mere 0.01% of the pixels inactive or always lit.

However, this is not a malfunction and does not affect the

recorded picture.

..............................................................................................

Viewfinder

≥Do not direct the Viewfinder or Lens to the sun. Internal

components may be seriously damaged.

≥When the Movie Camera is used with a large capacity

Battery (CGP-D28S/CGP-D320; optional) attached to it, it

is not practical to look in the Viewfinder from behind the

Battery. In this case, lift up the Viewfinder to an easy-to-see

angle.

..............................................................................................

Extremely high precision technology is employed to produce

the Viewfinder screen featuring a total of approximately

113,000 pixels. The result is more than 99.99% effective

pixels with a mere 0.01% of the pixels inactive or always lit.

However, this is not a malfunction and does not affect the

recorded picture.

..............................................................................................

Lens Hood

≥When attaching the Lens Hood, match the marks

on the

Movie Camera and the Lens Hood and turn.

≥Do not attach other conversion lenses in front of the Lens

Hood; there is no mount to be used for the attachment.

≥When you wish to attach the Tele Conversion Lens (VW-

LT3714ME; optional), Wide Conversion Lens (VW-

LW3707ME; optional), MC Protector (VW-LMC37E;

optional), or ND Filter (VW-LND37E; optional), first of all,

turn the Lens Hood counterclockwise. If the MC Protector

or ND Filter is used, the Lens Hood can be mounted on the

filter.

≥If you push the [W/T] Lever toward [W] during recording

with the filter or conversion lens attached to the Movie

Camera, 4 corners of the image may become dark

(vignetting). For details, please refer to the operating

instructions of your accessories.

≥Be sure to keep the Lens Hood attached to the Movie

Camera so as to shut out unnecessary light.

~~~~~~~~~~~~~~~~~~~

Before Requesting Repair (Problems

and Solutions)

Power

1: The Movie Camera power cannot be turned on.

1: Is the power source connected correctly? (l 10)

2: The Movie Camera power is turned off

automatically.

2: If you leave the Movie Camera in Recording Pause

Mode for more than 6 minutes, the power is turned off

automatically to protect the tape and to save the Battery

power. (l 18)

3: The Movie Camera power does not stay on long

enough.

3-1: Is the Battery low? Charge the Battery or attach a fully

charged Battery. (l 10)

3-2: Has condensation occurred? Wait until the

Condensation Indication disappears. (l 43)

Battery

1: Battery runs down quickly.

1-1: Is the Battery fully charged? Charge it with the AC

Adaptor. (l 10)

1-2: Are you using the Battery in an extremely cold place? In

cold places, the operating time of the Battery becomes

shorter. (l 44)

1-3: Has the Battery worn out? If the operating time is still

too short even after the Battery is fully charged, the

Battery has worn out.

2: The Battery cannot be charged.

2: If the DC Input Lead is connected to the AC Adaptor,

charging cannot be performed. Disconnect the DC Input

Lead.

Normal Recording

1: Recording does not start although power is

supplied to the Movie Camera and the Cassette is

correctly inserted.

1-1: Is the accidental erasure prevention slider on the

Cassette open? If it is open (set to [SAVE]), recording

cannot be performed. (l 11)

1-2: Is the tape wound to the end? Insert a new Cassette.

(l 11)

1-3: Is the Movie Camera power turned on? (l 18)

1-4: Is the [CAMERA] Lamp on? If the [CAMERA] Lamp is

not on, no recording function can be operated. (l 26)

1-5: Has condensation occurred? Wait until the

Condensation Indication disappears. (l 43)

Other Recording

1: Auto Focus Function does not work.

Panasonic NVDS38B Seite 45

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Panasonic NVDS38B

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info