Bedienungsanleitung Panasonic NVGS280EB (Seite 58 von 68) (Englisch)

627423

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

Others

VQT0T19

5: The movie camera cannot be operated

though powered up.

The movie camera does not operate

normally.

• The movie camera cannot be operated unless

you open the LCD monitor or extend the

viewfinder.

• Remove the cassette and then press the

[RESET] button. (

-60-) If normal conditions are

not restored yet, turn off the power. Then,

about 1 minute later, turn on the power again.

(Conducting the above operation when the

access lamp is on may destroy the data on the

card.)

6: The cassette cannot be removed.

• Does the Status indicator comes on when

opening the cassette cover? (

-11-) Make sure

that the battery and the AC adaptor are

properly connected. (

-9-)

• Is the battery in use discharged? Charge the

battery and remove the cassette.

• Close the cassette cover completely, and fully

open it again. (

-14-)

7: No operation other than cassette removal

can be performed.

• Has condensation occurred? Wait until the

condensation indication disappears. (

-60-)

8: The remote control does not function.

• Has the button-type battery of the remote

control run out? Replace it with a new button-

type battery. (

-22-)

• Is the setting on the remote control correct? If

the setting on the remote control is not in

agreement with the [REMOTE] setting on the

movie camera, the remote control does not

operate. (

-23-)

Recording

1: Recording does not start although power is

supplied to the movie camera and the

cassette is correctly inserted.

• Is the accidental erasure prevention slider on

the cassette open? If it is open (set to [SAVE]),

recording cannot be performed. (

-15-)

• Is the tape wound to the end? Insert a new

cassette.

• Is the recording mode set? When in the

playback mode, recording cannot be

performed. (

-24-)

• Has condensation occurred? No operation

other than cassette removal can be performed

when condensation occurs. Wait until the

condensation indication disappears. (

-60-)

• Is the cassette cover open? If the cover is

open, the movie camera may not operate

normally. Close the cassette cover. (

-14-)

2: The screen has changed suddenly.

• Has the demonstration started? In the Tape

Recording mode, if you set [DEMO MODE] >>

[ON] without inserting a cassette and a card,

the demonstration starts. For normal use, set

this function to [OFF]. (

-53-)

3: A cassette cannot be inserted.

• Has condensation occurred? Wait until the

condensation indication disappears.

4: Auto focus function does not work.

• Is manual focus mode selected? If auto focus

mode is selected, focus is automatically

adjusted.

• There are some recording subjects and

surroundings for which the auto focus does not

operate correctly. (

-64-) If so, use the manual

focus mode to adjust the focus. (

-38-)

• Is the colour night view function set? When the

colour night view function is working, focusing

shifts into the manual mode.

5: The camera arbitrarily stops recording.

• Is the AGS function activated? Record in the

normal horizontal position or set [AGS] to

[OFF].(

-32-)

Indications

1: A sentence is displayed in red in the screen

centre.

• Read the contents and respond to them. (-55-)

2: The time code becomes inaccurate.

0 The time code indication counter may not be

constant in the reversed slow-motion playback,

but this is not a malfunction.

3: The remaining tape time indication

disappears.

• The remaining tape time indication may

disappear temporarily during frame-by-frame

playback or other operation. If you continue

ordinary recording or playback, the indication is

restored.

4: The remaining tape time Indication does not

match the actual remaining tape time.

• If scenes of less than 15 seconds are

continuously recorded, the remaining tape time

cannot be correctly displayed.

• In some cases, the remaining tape time

indication may show remaining tape time that is

2 to 3 minutes shorter than the actual

remaining tape time.

5: A function indication such as mode

indication, remaining tape time indication,

or time code indication is not shown.

• If you set [SETUP] >> [DISPLAY] >> [OFF],

indications other than the tape running

condition, warning, and date indications

disappear.

GS300EB.book 58 ページ２００５年１１月１５日　火曜日　午後９時３８分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic NVGS280EB Seite 58

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info