Bedienungsanleitung Panasonic NVGS30EN (Seite 87 von 96) (Englisch)

627424

Zoom out

Zoom in

Vorherige Seite

1/96

Nächste Seite

Others

-87-

When you use your Movie Camera on a beach

or similar place, do not let sand or fine dust

get into the Movie Camera.

≥Sand or dust may damage the Movie Camera or

Cassette. (Care should be taken when inserting

and removing the Cassette.)

Do not spray insecticides or volatile

chemicals onto the Movie Camera.

≥If the Movie Camera is sprayed with such

chemicals, the camera body may be deformed

and the surface finish may peel off.

≥Do not keep rubber or plastic product in contact

with the Movie Camera for a long period of time.

Do not use benzine, thinner or alcohol for

cleaning the Movie Camera.

≥The camera body may be deformed and the

surface finish may peel off.

≥Before cleaning, detach the Battery or pull out

the AC Mains Lead from the AC mains socket.

≥Wipe the Movie Camera with a soft dry cloth. To

remove stubborn stains, wipe with a cloth that is

soaked in a detergent diluted with water and

afterward finish wiping with a dry cloth.

≥For storing or transporting the Movie Camera,

place it in a bag or case lined with soft pads so

as to prevent the coating on the camera body

from being worn.

After use, be sure to take the Cassette out and

detach the Battery from the Movie Camera or

pull out the AC Mains Lead from AC mains

socket.

≥If the Cassette is left in the Movie Camera, the

tape sags and deteriorates.

≥If the Battery is left on the Movie Camera for a

long time, the voltage drops excessively, and

the Battery will not function even after it is

recharged.

ª About AC Adaptor

≥If the temperature of the Battery is extremely

high or extremely low, the [CHARGE] Lamp

may continue flashing, and the Battery may not

be charged. After the temperature of the Battery

has decreased or increased sufficiently,

charging starts automatically. If the [CHARGE]

Lamp continues to flash even after the Battery

temperature has decreased or increased

sufficiently, the Battery or AC Adaptor may be

faulty. In this case, please contact a dealer.

≥If the Battery is warm, charging takes a longer

time than normal.

≥If you use the AC Adaptor near a radio, radio

reception may be disturbed. Keep the AC

Adaptor 1 metre or more away from radio.

≥When the AC Adaptor is in use, it may generate

whirring sounds. However, this is normal.

≥After use, be sure to pull out the AC Mains Lead

from the AC mains socket. (If they are left

connected, a minute amount of current is

consumed.)

≥Keep the electrodes of the AC Adaptor and

Battery always clean.

ª Condensation

If the Condensation Indication flashes after the

Movie Camera is turned on, condensation has

formed inside the Movie Camera. In this case, the

Movie Camera power is turned off automatically

after about 1 minute.

Follow the steps below:

1 Take out the Cassette.

≥None of the other functions operate.

Depending on the amount of condensation,

removing the Cassette may even become

difficult. If this happens, wait for 2 to 3 hours

before taking the Cassette out.

2 Open the Cassette Compartment Cover and

wait for 2 to 3 hours.

≥The number of hours to wait depends on the

amount of condensation and ambient

temperature.

3 2 to 3 hours later, turn on the Movie Camera

power and check to see if the Condensation

Indication is displayed.

≥Even if the Condensation Indication is not

displayed, as a precaution, please wait for

another hour before using the Movie Camera.

Watch for Condensation even before the

Condensation Indication is displayed.

≥Because condensation takes place gradually,

the Condensation Indication may not be

displayed during the first 10 to 15 minutes of

condensation formation inside the Movie

Camera.

≥In extremely cold places, condensation may

freeze and form frost. In this case, the frost

melts first, thus forming condensation, and then

it takes another 2 to 3 hours to eliminate the

condensation.

When the Lens is Fogged:

Set the [OFF/ON/MODE] Switch to [OFF] and

leave the Movie Camera in this condition for

about 1 hour. When the lens temperature

becomes close to the ambient temperature, the

fog disappears naturally.

ª Video Head Clogging and Care

If the heads (the parts that make contact with

tape) are dirty, mosaic-pattern noise may appear

on the playback image, or the screen as a whole

becomes black. If the heads are extremely dirty,

recording performance deteriorates, and, in the

worst case, the Movie Camera cannot record at

all.

30EN-ENGText.auto.fm 87 ページ２００９年７月８日　水曜日　午後４時５６分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic NVGS30EN Seite 87

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info