Bedienungsanleitung Panasonic NVGS33EG (Seite 9 von 52) (Englisch)

627432

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

Before Use

-9-

≥Make sure to match the poles correctly when

inserting the battery.

ª Using the Remote Controller

1 Direct the Remote Controller at the Remote

Control Sensor

(29) of the Movie Camera

and press an appropriate button.

≥Distance from the Movie Camera: Within

approximately 5 metres

≥Angle: Within approximately 15o in the

vertical and horizontal directions from the

central axis

≥The above operating ranges are for indoor use.

Outdoors or under strong light, the Movie

Camera may not operate properly even within

the above ranges.

≥Within a 1-metre range, you can also use the

Remote Controller on the LCD Monitor side of

the Movie Camera.

Selecting Remote Controller Modes

When 2 Movie Cameras are used

simultaneously, they can be operated individually

by selecting different Remote Controller Modes.

WARNING

“THE LITHIUM BATTERY IS A CRITICAL

COMPONENT (TYPE NUMBER CR2025

MANUFACTURED BY PANASONIC).

IT MUST NEVER BE SUBJECTED TO

EXCESSIVE HEAT OR DISCHARGE. IT

MUST THEREFORE ONLY BE FITTED IN

EQUIPMENT DESIGNED SPECIFICALLY

FOR ITS USE.

REPLACEMENT BATTERIES MUST BE OF

THE SAME TYPE AND MANUFACTURER.

THEY MUST BE FITTED IN THE SAME

MANNER AND LOCATION AS THE

ORIGINAL BATTERY, WITH THE

CORRECT POLARITY CONNECTIONS

OBSERVED.

DO NOT ATTEMPT TO RE-CHARGE THE

OLD BATTERY OR RE-USE IT FOR ANY

OTHER PURPOSE. IT SHOULD BE

DISPOSED OF IN WASTE PRODUCTS

DESTINED FOR BURIAL RATHER THAN

INCINERATION.”

15˚

(29)

≥If the Remote Controller Mode of the Movie

Camera and that of the Remote Controller do

not match, [REMOTE] Indication is displayed.

Setup on the Movie Camera:

Set [REMOTE] on the [INITIAL] Sub-Menu to the

desired Remote Controller Mode. (

-15-)

Setup on the Remote Controller:

[VCR1]:

Press the [D] Button and [∫] Button

simultaneously. 1

[VCR2]:

Press the [E] Button and [∫] Button

simultaneously. 2

≥When the battery in the Remote Controller is

replaced, the mode is automatically reset to

[VCR1] Mode.

Power Supply

ª Using the AC Adaptor

Connect the DC Input Lead to the Movie

Camera.

2 Connect the DC Input Lead to the AC

Adaptor.

3 Connect the AC Mains Lead to the AC

Adaptor and the AC mains socket.

≥The AC Mains Lead’s outlet plug does not fit

entirely into the AC Adaptor socket. A gap will

remain as shown 1.

≥Before connecting or disconnecting the

power supply, set the [OFF/ON] Switch on

the Movie Camera to [OFF] and make sure

that Power Lamp is not lit.

ª Using the Battery

Before use, fully charge the Battery.

≥We recommend using Panasonic’s Battery.

≥We cannot guarantee the quality of this Movie

Camera when batteries of other companies are

used.

INDEX INDEX

SELECT

STOP

∫

STILL ADV

PAU SE

STILL ADV

61 5

;

P.B. ZOOM

33B-ENG.book 9 ページ２００４年２月４日　水曜日　午前１１時５５分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic NVGS33EG Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Panasonic NVGS33EG

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info