Bedienungsanleitung Panasonic NVMX1B (Seite 49 von 54) (Englisch)

627470

Zoom out

Zoom in

Vorherige Seite

1/54

Nächste Seite

Miscellaneous/

Care of Unit/Options

After Use, Always Remove the Battery.

Be sure to remove the Battery from the Movie

Camera. (If it is attached to the Movie Camera, a

small amount of electric current is consumed even if

the Movie Camera is turned off.) Leaving the Battery

attached to the Movie Camera for a very long time

could cause it to become excessively discharged, so

that it cannot be used any more even after charging.

Keep the Battery’s Terminals Clean.

Be careful that the terminals do not get plugged up

with dust, dirt or other substances.

If you accidentally drop the Battery, confirm that

the Battery itself and the terminals are not

deformed. Attaching a deformed Battery to the

Movie Camera or to the AC Adaptor could damage

the Movie Camera or the AC Adaptor.

Discarding a Battery That Has Become

Unusable

≥The usable life of the Battery is limited.

≥Do not throw the Battery in a fire because it could

explode.

∫ Precautions for Storage

Before Storing the Movie Camera, Take out the

Cassette and Remove the Battery.

Store all equipment in a dry place where the

temperature remains relatively constant.

(Recommended temperature is 15°C–25°C and

recommended relative humidity is 40%–60%.)

Movie Camera

≥Wrap it with a soft cloth to prevent dust form

entering.

≥Never leave the Movie Camera in places with

high temperature.

Battery

≥Extremely low or high temperature shortens the

Battery life.

≥Storing it in places with oily smoke and a lot of

dust could cause the terminals to get rusty, and

this can result in a malfunction.

≥Do not allow metal objects (such as

necklaces and hair pins) to touch the battery

terminals. Short-circuiting may occur and

generate heat, and touching it in this

condition could inflict serious burns.

≥Store the Battery in discharged condition. If you

store the Battery for a long time, it is

recommended that you charge it once a year and

completely use up the charge before storing it

again in discharged condition.

Cassette

≥Rewind the tape to its beginning before storing.

Leaving the cassette with the tape stopped

halfway for more than 6 months (depending on

the storing condition) loosens the tape. Be sure

to rewind it to the beginning.

≥

Put the cassette in its case to store it.

Dust, direct sunlight (ultraviolet rays) and humidity

could damage the tape. Dust contains hard mineral

particles and cassettes with dust damage the video

heads and other parts of the Movie Camera. Make it

a habit to always put the cassette back into its case.

Cautions for Use

(Continued)

∫ Condensation

Determining Whether Condensation Has

Formed Inside and Remedy for Condensation

If the Condensation Indication flashes after you

turn on the Movie Camera, condensation has

formed inside the Movie Camera. In this case, the

Movie Camera automatically switches off after

approximately 1 minute.

Remedy as follows:

1 Take out the cassette.

All other functions do not work. Depending on

the amount of condensation, it may not be

possible to take out the cassette. In this case,

wait 2–3 hours before taking out the cassette.

2 Leave the Cassette Compartment open and

wait for 2–3 hours.

The required time depends on the amount of

condensation and the ambient temperature.

3 After 2–3 hours, turn the Movie Camera on

and check if the Condensation Indication

is displayed.

Even if the Condensation Indication is no

longer displayed, wait 1 more hour for added

safety before using the Movie Camera again.

Pay Attention to Condensation Even Before the

Condensation Indication Appears.

≥As condensation forms gradually, the

Condensation Indication may not appear for the

first 10–15 minutes after condensation has

formed inside.

≥In an extremely cold place, the condensation

could freeze and turn into frost. In such a case, it

takes an additional 2–3 hours for the frost to first

melt into condensation and then to be dissolved.

Remedy for a Fogged-up Lens

Set the [OFF/ON/MODE] Switch to [OFF] and

leave the Movie Camera in this condition for about

1 hour. When the lens has reached about the

same temperature as its surroundings, it

automatically clears up.

Periodic Inspection

To ensure optimum picture quality, it is

recommended that you have worn-out parts such

as video heads replaced after approximately

1000 hours of use. (However, this depends

considerably on the conditions of use such as

temperature, humidity and dust.)

∫ Optimum Use of the Battery

Special Characteristics of the Battery

This Battery is a rechargeable lithium-ion battery. Its

ability to generate electric energy is based on an

internal chemical reaction. This reaction is easily

influenced by ambient temperature and humidity, and

the useful operation time that the Battery can provide

becomes shorter at high and low temperatures. When

used in extremely cold surroundings, the Battery may

only be able to provide approximately 5 minutes of

operation time. If the Battery becomes extremely hot,

a protection function is activated and prevents the use

of the Battery for some time.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic NVMX1B Seite 49

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info