542439
17
Zoom out
Zoom in
Vorherige Seite
1/81
Nächste Seite
ENGLISH -
17
Preparation
About Your Projector
Remote control
(1) <AUTO SETUP> Button
Execute the setting of Auto setup in the setting
menu. (
Æ
page 53)
(2) Input Selection Buttons: <COMPUTER 1>,
<COMPUTER 2>, <HDMI>, <VIDEO>,
<S-VIDEO>, <COMPONENT>.
These buttons are used to select the input signal.
(
Æ
page 33)
(3) ▲▼◄► Buttons, <SELECT> Button
Navigate the MENU display. (
Æ
page 37)
(4) <SCREEN> Button
Select a screen mode. (
Æ
page 49)
(5) <MENU> Button
Open or close the On-Screen Menu. (
Æ
page 37)
(6) <FREEZE> Button
Pause the projected image and sound tentatively.
(
Æ
page 34)
(7) <AV MUTE> Button
Temporarily turn off the image on the screen.
(
Æ
page 35)
(8) <D.ZOOM +/-> Buttons
Zoom in and out the images.(
Æ
page 33)
(9) <VOLUME +/-> Buttons
Adjust the volume of the speaker. (
Æ
page 35)
(10) < > Button
Turn the projector on or off. (
Æ
page 28)
(11) <KEYSTONE> Button
Correct keystone distortion. (
Æ
page 34)
(12) <INFO.> Button
Operate the information function. (
Æ
page 34)
(13) <LAMP> Button
Select a lamp mode. (
Æ
page 35)
(14) <P-TIMER> Button
Operate the P-timer function. (
Æ
page 35)
(15) <3D> Button
Operate the 3D function. (
Æ
page 36)
(16) <IMAGE> Button
Select the image mode. (
Æ
page 35)
(17) <MUTE> Button
Mute the sound. (
Æ
page 36)
(18) Remote control signal emitter
Attention
Do not drop the remote control.
z
Avoid contact with liquids.
z
Do not attempt to modify or disassemble the remote
z
control.
Note
If there are any obstacles between the remote control
z
and the remote control signal receptor, the remote control
may not operate correctly.
You can operate the projector by reecting the remote
z
control signal on the screen. The operating range may
differ due to the loss of light caused by the properties of
the screen.
When the remote control signal receptor is lit with a
z
uorescent light or other strong light source, the projector
may become inoperative. Set the projector as far from
the luminous source as possible.
Point the remote control toward the projector (remote
z
control signal receptor) when pressing the buttons. See
the below gures indicating Maximum operating range for
the remote control.
16.4’
(5 m)
16.4’
(5 m)
11.5’
(3.5 m)
(1)
(10)
(2)
(4)
(5)
(6)
(8)
(7)
(9)
(17)
(16)
(15)
(14)
(13)
(12)
(11)
(3)
(18)
17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Panasonic PT-CW230EA wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info