542439
61
Zoom out
Zoom in
Vorherige Seite
1/81
Nächste Seite
LAMP and WARNING Indicators
ENGLISH -
61
Maintenance
LAMP and WARNING Indicators
Managing the indicated problems
If a problem should occur inside the projector, the <ON(G)/STANDBY(R)> , <LAMP> and/or <WARNING>
indicators will inform you. Manage the indicated problems as follow.
CAUTION
Before you take a remedial measure, follow the procedure of switching the power off indicated in “Turning off the projector”.
z
(
Æ
page 30)
If multiple indicators light or blink, verify the status of the projector by looking at each indicator.
z
Note
Conrm the status of the power indicated on the
z
<ON(G)/STANDBY(R)>
indicator.
J
LAMP indicator
Indicator
Lights in yellow.
Status
The projection lamp reaches its end of life.
Check
Is there a Lamp replacement icon appears on the screen?
Remedy
Replace the lamp unit.
(
Æ
page 65)
Note
Contact your dealer for repair services when <LAMP> indicator persists to light after taking these measurements.
z
J
WARNING indicator
Indicator
Lights in red. Blinks in red.
Status
The projector detects an abnormal
condition and cannot be turned
on.
The temperature inside the projector is abnormally high.
The projector cannot be turned on. And the <ON(G)/
STANDBY(R)> indicator also blinks in red.
Check
Unplug the AC power cord
and plug it again to turn on the
projector.
- Did you provide appropriate space for the projector to be
ventilated? Check the installing condition to see if the air
vents of the projector are not blocked.
- Has the projector been installed near an Air-
Conditioning/ Heating Duct or Vent?
- Is the lter clean?
Remedy
If the projector is turned off again,
unplug the AC power cord and
contact the dealer or the service
center for service and checkup.
- Provide good installing condition to your projector.
- Move the installation of the projector away from the duct
or vent.
- Replace the lter unit.
Note
If <WARNING> indicator persists to light or blink after taking these measurements, please contact your dealer for repair
z
services. Do not leave the projector on. It may cause an electric shock or a re hazard.
The projector detects an abnormal condition and cannot be turned on. Unplug the AC power cord and plug it again to turn
z
on the projector. If the projector is turned off again, unplug the AC power cord and contact the dealer or the service center
for service and checkup. Do not leave the projector on. It may cause an electric shock or a re hazard.
61

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Panasonic PT-CW230EA wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info