Bedienungsanleitung Panasonic PT-DS20K2 (Seite 65 von 223) (Englisch)

598881

Zoom out

Zoom in

Vorherige Seite

1/223

Nächste Seite

Chapter 3 Basic Operations — Projecting

ENGLISH - 65

Projecting

Check the projection lens attachment (x page 50), external device connection (x page 52), power cord

connection (x page 58), switch on the power (x page 59) to start projecting. Select the video for projection,

and adjust appearance of the projected image.

Selecting the input signal

Select an input signal.

1) Press the input selection button (<RGB1>, <RGB2>, <DIGITAL LINK>, <DVI-D>, <HDMI>, <SDI 1/2>, or

<SDI>) on the remote control or the control panel.

(SDI input is supported only for PT-DZ21K2, PT-DS20K2, and PT-DZ16K2.)

f The image of the signal being input in the selected terminal is projected.

Attention

f Images may not be projected properly depending on the external device, or the blu-ray disc or DVD disc, to be played back.

Set the [PICTURE] menu → [SYSTEM SELECTOR].

f Conrm the aspect ratio of the projection screen and the image, and switch to an optimum aspect ratio from the [POSITION] menu →

[ASPECT].

Adjusting the focus, zoom, and shift

If the projected image or the position is not correct when the positioning of the projector and the screen is correctly

installed, adjust the focus, zoom, and shift.

This section describes the adjustment method when anything other than the xed-focus lens (Model No.:

ET-D75LE90) is used. When the xed-focus lens (Model No.: ET-D75LE90) is used, refer to “Adjusting the lens

position and focus when the xed-focus lens (Model No.: ET-D75LE90) is used” (x page 66).

Using the control panel

1) Press the <LENS> button on the control panel.

f Pressing the button changes the adjustment screen in the order of [FOCUS], [ZOOM], and [SHIFT].

2) Select each item and press asqw to adjust it.

Using the remote control

1) Press the lens buttons (<FOCUS>, <ZOOM>, <SHIFT>) on the remote control.

f <FOCUS> button: Adjusts focus.

f <ZOOM> button: Adjusts zoom.

f <SHIFT> button: Adjusts shift.

2) Select each item and press asqw to adjust it.

CAUTION

During the lens shift operation, do not insert your hand in any opening around the lens.

Your hand may be caught in between, resulting to injury.

Note

f When the projection lens without the zoom function is attached, the zoom adjustment screen will be displayed. However, operation is not

possible.

f When the xed-focus lens (Model No.: ET-D75LE50) is used, do not use the shift adjustment, and use the projector with the lens position at

the home position. (x page 67)

f The adjustment can be performed faster by pressing and holding asqw for approximately three seconds or longer while adjusting the

focus and shift.

f It is recommended that images be projected continuously for at least 30 minutes before the focus is adjusted.

f Only [FOCUS] is shown in yellow so that the displayed menu item can be recognized by color, even when the projector is not focused and

displayed characters are unreadable. (Factory default)

The display color of [FOCUS] depends on the setting of the [DISPLAY OPTION] menu → [ON-SCREEN DISPLAY] → [OSD DESIGN].

f When the power is switched off during focus and shift adjustment, lens calibration needs to be performed the next time the power is

switched on. (x page 140)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic PT-DS20K2 Seite 65

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Panasonic PT-DS20K2

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info