Bedienungsanleitung Panasonic PT-DW830E (Seite 16 von 190) (Englisch)

543731

Zoom out

Zoom in

Vorherige Seite

1/190

Nächste Seite

Chapter 1 Preparation — Precautions for use

16 - ENGLISH

Precautions for use

Cautions when transporting

f If you purchased the projector with the standard zoom lens, remove the lens cushion before use, and store it for the future

use. When transporting the projector, move the lens position to the home position and attach the lens cushion.

If you purchased the projector with the lens sold separately, remove the lens hole cover before use, and store it for the future

use. When transporting the projector, move the lens position to the home position, remove the projection lens, and then

attach the lens hole cover.

For the steps to move the lens to the home position, refer to “Moving the lens to the home position” (x page 59).

Lens hole cover

Lens cushion

f When transporting the projector, hold it securely by its bottom and avoid excessive vibration and impacts. They may damage

the internal components and result in malfunctions.

f Do not transport the projector with the adjustable feet extended. Doing so may damage the adjustable feet.

Cautions when installing

rAfter attachment of the projection lens, be sure to attach the Lens Mount Cover.

Otherwise dust will accumulate inside and may cause malfunctions.

rDo not set up the projector outdoors.

The projector is designed for indoor use only.

rDo not set up the projector in the following locations.

f Places where vibration and impacts occur such as in a car or vehicle: Doing so may cause damage to internal components

or malfunction.

f Near the exhaust of an air conditioner: Depending on the conditions of use, the screen may uctuate in rare cases due

to the heated air from the air exhaust port or the hot or cooled air. Make sure that the exhaust from the projector or other

equipment, or the air from the air conditioner does not blow toward the front of the projector.

f Places with sharp temperature uctuations such as near lights (studio lamps): Doing so may shorten the life of the lamp, or

result in deformation of the outer case due to heat, which may cause malfunctions.

The operating environment temperature of the projector should be between 0 °C (32 °F) and 45 °C (113 °F) when using it at

elevations lower than 1 400 m (4 593') above sea level, and between 0 °C (32 °F) and 40 °C (104 °F) when using it at high

altitudes (1 400 m (4 593') or higher – lower than 2 700 m (8 858') above sea level).

f Near high-voltage power lines or near motors: Doing so may interfere with the operation of the projector.

f Places where there is high-power laser equipment: Directing a laser beam onto the projection lens surface causes damage

to the DLP chips.

rBe sure to ask a specialized technician or your dealer when installing the projector on

a ceiling.

The optional Ceiling Mount Bracket is required.

Model No.: ET-PKD120H (for high ceilings), ET-PKD120S (for low ceilings), ET-PKD120B (Projector Mount Bracket)

rAsk a qualied technician or your dealer to install the cable wiring for DIGITAL LINK

connection.

Image and sound may be disrupted if cable transmission characteristics cannot be obtained due to inadequate installation.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic PT-DW830E Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Panasonic PT-DW830E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info