734657

Panasonic RC-800 Seite 2

2
Zoom out
Zoom in
Vorherige Seite
1/2
Nächste Seite
Time and alarm settings
This is a 24-hour clock.
(Only when the unit is in standby mode)
1 Press and hold [jTIME SET] for at least 2 seconds.
2 Set the time. (Hours and minutes)
≥ Press [HOUR] repeatedly to adjust the hour.
≥ Press [MINUTE] repeatedly to adjust the minute.
3 Press [SNOOZE / BRIGHTNESS / ENTER].
≥ Reset the clock regularly to maintain accuracy.
You can set two alarms with different desired settings.
Preparation
≥ Ensure the time is set.
≥
To set FM as the alarm source, ensure to preset your desired stations to the FM channels.
(Only when the unit is in standby mode)
1 Press and hold [ALARM/jSET, 1] or [ALARM/jSET, 2] for at least 2 seconds.
2 Set the alarm time.
≥ Press [HOUR] repeatedly to adjust the hour.
≥ Press [MINUTE] repeatedly to adjust the minute.
3 Press [SNOOZE / BRIGHTNESS / ENTER] to confirm the alarm time.
4 Press [TUNE / SELECT X, W] to select desired item or setting and then press
[SNOOZE / BRIGHTNESS / ENTER].
≥ Set the audio source.
Source: BUZZ, FM
If FM is set, select a preset station as the audio source.
≥ Set the volume (8 (minimum) to 16 (maximum))
The alarm starts at a low volume and increases gradually to the preset level.
(Volume adjustment made using [VOLUME j, i] will not affect the alarm volume.)
After you complete the alarm setup, the corresponding alarm will be turned on.
Time
Alarm
To check the alarm settings
Press [ALARM/jSET, 1] or [ALARM/jSET, 2] when the unit is in standby mode. (The
alarm time and source will be shown, followed by the alarm volume.)
∫ Turning the alarm on/off
The alarm will sound at the set time every day for a duration of 59 minutes.
You can turn the alarm on/off as desired.
(Only when the unit is in standby mode)
Press [ALARM/
jSET, 1]
or [ALARM/
jSET, 2]
twice to turn the corresponding alarm
on/off.
≥ The corresponding alarm indicator (“ ” or “ ”) will be displayed when its alarm is
turned on.
To stop the sounding alarm
Press [Í/I] or press the corresponding alarm button ([ALARM/jSET, 1] or
[ALARM/jSET, 2]).
To snooze the sounding alarm
Press
[SNOOZE / BRIGHTNESS / ENTER] to put the alarm into snooze mode.
≥ The unit will switch into standby mode and the corresponding alarm indicator (“ ” or “ ”)
blinks slowly.
≥ Snooze interval is 5 minutes.
≥ Press [Í/I] to turn on the unit will also stop the snooze mode.
≥ The alarm works in both unit on and standby modes.
Sleep timer
The sleep timer can turn the unit off after a set time.
Press [SLEEP] repeatedly to select the setting (in minutes).
– OFF, 30, 60, 90, 120
≥ “Zz” is displayed when the sleep timer is set.
≥ To cancel, select “OFF”.
≥ Pressing [SLEEP] while the sleep timer is set allows you to check the remaining time.
Display brightness
Press [SNOOZE / BRIGHTNESS / ENTER] repeatedly to select desired display
brightness (low, medium, high).
≥ You can change the display brightness during unit on or standby mode.
≥ You cannot change the brightness during setting mode or when the alarm sounds.
1
2
1
2
Troubleshooting
Before requesting service, make the following checks. If you are uncertain about some of
the check points, or if the solutions indicated in the following guide does not resolve the
issue, then consult your dealer for instructions.
Sound is distorted or no sound.
≥ Adjust the volume.
≥ If the AC adaptor or fluorescent lights are near the cords, then keep other appliances and cords away
from the cables.
The unit does not work.
≥ One of the unit’s safety devices may have been activated.
1 Press [Í/I] to switch the unit to standby.
≥ If the unit does not turn off, disconnect the AC adaptor from the AC mains socket. After about 30
seconds, reconnect the AC adaptor to the AC mains socket. Then wait for about 10 seconds.
2 Press [Í/I] to switch it on. If the unit still cannot be operated, consult the dealer.
Static or noisy reception is heard while listening to a radio broadcast.
≥ Check and adjust the antenna.
≥ Try to keep a certain amount of distance between the antenna and AC adaptor.
≥ Turn the TV or other audio players off or separate it from this unit.
≥ Keep this unit away from mobile phones if there is interference.
Maintenance
Disconnect the AC adaptor from the outlet before maintenance.
∫ Clean this unit with a soft, dry cloth
≥ When dirt is heavy, wring a wet cloth tightly to wipe the dirt, and then wipe it with a dry cloth.
≥ Never use alcohol, paint thinner or benzine to clean this unit.
≥ Before using chemically treated cloth, carefully read the cloth’s instructions.
∫ To dispose or transfer this unit
The unit may keep the user settings information in the unit. If you discard this unit either by
disposal or transfer, then follow the procedure to return all the settings to the factory defaults to
delete the user settings. (l Troubleshooting, “To return all settings to the factory defaults”)
To return all settings to the factory defaults
Press and hold [Í/I] for at least 10 seconds.
“-- --” appears for about 2 seconds.
≥ The settings are returned to the factory defaults. It is necessary to set the settings again.
General
Radio
Specifications
≥ Specifications are subject to change without notice.
≥ Mass and dimensions are approximate.
≥ Total harmonic distortion is measured by a digital spectrum analyzer.
∫ GENERAL
Power supply
AC adaptor
Input AC 100 V to 240 V, 50/60 Hz, 0.3 A
Output (For Australia and New Zealand) DC 5.0 V, 1.0 A
(For others) DC 5.0 V, 1.0 A, 5.0 W
Main unit
Power supply input
DC IN DC 5 V, 1 A
Power consumption 3W
Power consumption in standby mode
(With display brightness set at medium level) Approx. 0.8 W
Memory backup batteries 3V (2kR6/LR6)
Dimensions (WkHkD) 150 mmk89 mmk90 mm (including protrusions)
Mass
Without batteries Approx. 0.42 kg
With batteries Approx. 0.47 kg
Operating temperature range 0 oC to r40 oC
Operating humidity range 20% to 80% RH (no condensation)
∫ AMPLIFIER SECTION
Output power
RMS output power
Front Ch 1 W Mono (8 ≠), 1 kHz, 10% THD
∫ TUNER SECTION
Preset Memory FM 10 stations
Frequency Modulation (FM)
Frequency range 87.50 MHz to 108.00 MHz (50 kHz step)
∫ SPEAKER SECTION
Speaker unit
Full Range 5cmconetypek1
RC-800_TQBJ2233_eng.fm 2 ページ ２０２０年６月３０日　火曜日　午後３時１０分
2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Panasonic RC-800 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Panasonic RC-800

Panasonic RC-800 Bedienungsanleitung - Deutsch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Polnisch, Schwedisch, Norwegisch, Finnisch - 92 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info