Bedienungsanleitung Panasonic SA-XR700 (Seite 33 von 48) (Englisch)

502462

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

RQT8743

Settings

ENGLISH

Setting speakers and

their sizes

• You can set connected

speakers and their sizes

manually.

• Different ranges are played

by different speakers. Size

setting is necessary for

reproducing sources,

particularly their bass

section, completely.

1 Select and confirm the choice.

2 Select a speaker for setting and

confirm the choice.

3 Change a setting and confirm the

choice.

To go back to step 1

Select and confirm the choice.

When you set the front speakers (LR) as “LARGE ”

• The subwoofer also makes audio output in the

bass range when you perform stereo playback

of analogue and PCM sources.

• The subwoofer sends out only the LFE (low

frequency effect channel) signal contained in

2-channel Dolby Digital or DTS sources when

you play them in stereo.

SUBW : Subwoofer

LR : Front speakers

C : Center speaker

S : Surround speakers

SB : Surround back speakers

SUBW : NO ; unconnected YES ; connected

LR, C, S :

NONE ;

For speakers you haven’t connected (center or

surround only).

SMALL ;

For speakers that cannot adequately

reproduce the bass range. This setting is

sufficient for most speakers if you are using a

subwoofer.

LARGE ;

For speakers that can sufficiently reproduce

the bass range down to 20 Hz.

SB :

NONE ;

For speakers you haven’t connected.

1-SPK ;

If you connect one surround back speaker.

2-SPK ;

If you connect two surround back speakers.

Factory settings: LR, C, S ; SMALL

SUBW ; YES

SB ; 2-SPK

• Set the lowpass filter frequency according to frequencies available for playback when speakers

are set as “SMALL ”. The factory setting is 80 Hz. (below)

• The following are set automatically.

When you set “LR

” to “SMALL

”, “SUBW

” is set to “YES

”.

When you set “SUBW ” to “NO ”, “LR

” is set to “LARGE

”.

•“SB ” does not appear when “S ” is set to “NONE ”.

• The “SB

” size becomes the “S

” size because the unit does not offer “SB

” size setting.

• When you change the number of connected speakers, settings made with the setup microphone

are cancelled. (á pages 22 and 23)

Setting distances

• By adjusting the distance

from each speaker (except

the subwoofer) to the

seating area, the sound

delay time is automatically

adjusted so that sound

reaches the listener at the

same time.

1 Select and confirm the choice.

2 Select a speaker for setting and

confirm the choice.

3 Select a distance and confirm the

choice.

L : Front left R : Front right

C : Center LS : Surround left

RS : Surround right

SBL : Surround back left

SBR : Surround back right

Adjustment range: 0.5 to 15.0 m

This unit is adjusted at 0.1 meter intervals.

Factory settings: L, R ; 3.0 m

C ; 3.0 m

LS, RS ; 1.5 m

SBL, SBR ; 1.5 m

• Speakers whose polarity was automatically adjusted through the auto speaker setup using the

setup microphone are displayed with “– ” such as “L 3.0 – ”.

• When the speaker distance measured through the auto speaker setup (á pages 22 and 23)

exceeds 15 meters, the distance is displayed as “OVER ”.

Setting the lowpass

filter

• If the speaker sizes (above)

are set to “SMALL”, make

this setting.

• The unit cannot reproduce the

entire bass range when speakers

are set as “SMALL ”. You can

arrange the unit to provide missing

bass sounds through the

subwoofer by setting the lowpass

filter frequency according to

frequencies available for playback.

1 Select and confirm the choice.

2 Select the lowpass filter frequency

and confirm the choice.

Lowpass filter frequency for sending the bass

range to the subwoofer:

80, 100, 120, 140, 160, 180, 200 (Hz)

Factory setting: 80 (Hz)

The setting made through these steps applies to all speakers set as “SMALL

”.

Note

SA_XR700_EG_GN_ (RQT8743_B)ver.3.fm 33 ページ２００６年８月３１日　木曜日　午前９時７分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic SA-XR700 Seite 33

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Panasonic SA-XR700

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info