Bedienungsanleitung Panasonic SBR1E (Seite 7 von 128) (Deutsch, Englisch, Holländisch, Dänisch, Französisch, Italienisch, Spanisch, Schwedisch, Finnisch)

608311

Zoom out

Zoom in

Vorherige Seite

1/128

Nächste Seite

English

Installation

≥Each speaker must be carried and installed by at least two people.

≥Do not touch the speaker units. Doing so may result in incorrect audio quality.

≥Place the speakers at approximately the same distance from the listening position.

≥The speakers produce bass sound from the bass reflex ports on the rear as well as from the front. Install the speakers at least

5cm (2z) away from the walls so that they do not cover the bass reflex ports on the rear.

≥Keep the amplifier or any other device and the speakers at least 1 cm (

/32z) away from each other.

∫ For optimum position

The quality and volume of the bass sound, sound localisation performance, sound ambience, and other factors that determine the

audio quality vary depending on the installation location of this unit, listening position, room conditions, and other factors. Refer to

the information below when installing the speakers.

Determining an installation location.

≥Each speaker has a mass of approximately 72 kg (159 lbs). Check that the installation location is strong enough to bear this

mass.

≥If you need to secure the speakers against tipping over, consult an installation specialist. The strength of the floor and wall must

be verified. (> 10)

≥Put the speakers on a flat safe surface.

If the speakers wobble when placed, use the spacers. (> 8)

≥To minimise the gap in audio quality between the left and right speakers, install them so that acoustic conditions (reflection and

absorption of sound) around them are the same.

Adjusting the distances between the rear of the speakers and the walls

If you install the speakers close to a wall or in a corner, the bass sound will be more powerful; however, when the speakers are

too close to it, sound localisation performance and sound ambience may deteriorate. If this occurs, adjust the distance between

the speakers and the front wall, which should be between 30 cm (12z) to 60 cm (24z). (Please note that the distance between the

speakers and the side walls should be greater than 60 cm (24z).)

≥Do not drag the speakers with force. Doing so may cause the pads on their feet to peel off, damaging the speakers and floor.

Adjusting the angle of the speakers

Angle the front side of the speakers toward the listener. Following these steps will help the speakers deliver more precise sound

localisation.

Adjusting the acoustics of the room and speaker layout

Depending on the room environment (including the size and shape of the room, distance to the walls and reverberation level),

certain sounds may be exaggerated or suppressed, making them difficult to hear. In such cases, adjusting the reverberation level

by moving the speakers, changing your listening position or covering the walls and windows with thick curtains may help resolve

the problem.

≥The spikes may enhance the audio quality. (> 8)

60°

e.g.,

The angle is approximate.

※ Speaker units

※

(7)

SB-R1_SQT0465_PPCEBEGGN_mst.book 7 ページ２０１５年１月２３日　金曜日　午後４時４３分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic SBR1E Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Panasonic SBR1E

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info