Bedienungsanleitung Panasonic SBTP10EB (Seite 6 von 6) (Englisch)

612614

Zoom out

Zoom in

Vorherige Seite

1/6

Nächste Seite

Matsushita Electric Industrial Co., Ltd.

Web Site : http://www.panasonic.co.jp/global/

RQT6901-B

M1202TK0

Notes

Speaker impedance and allowed input

SB-FS702 / SB-PC702 Impedance 6 Ω

Input power 100 W (DIN)

SB-FS802 / SB-PC802

Impedance 6 Ω

Input power 40 W (DIN)

The only receivers or amplifiers you should connect to these speak-

ers are those whose rated output does not exceed the above figures.

Using a receiver or amplifier with higher ratings than listed above can

cause abnormal sounds to occur because of excessive input, dam-

age to the receiver or speakers, and fire. If equipment is damaged in

any way or unexpected trouble occurs during playback, unplug the

system from its outlet and call a serviceman for help.

Protection circuitry

SB-FS702 / SB-PC702 / SB-FS802 / SB-PC802

These units incorporate protection circuitry to protect them from dam-

age caused by excessive input or abnormal signals; when excess

input is detected, input is automatically interrupted.

If sound is interrupted...

1.Reduce the volume of the receiver (or amplifier).

2.Check the sound source and connections for any problems.

If there is no problem, the protection circuitry will reset in a few

minutes.

After the protection circuit is reset...

Take care not to increase the receiver’s volume too high.

Excessive input

You can damage your speakers and shorten their useful

life if you play sound at high levels over extended periods.

Reduce the volume in the following cases to avoid damage :

•When playing distorted sound.

•When the speakers are receiving howling from a microphone or

record player, noise from FM broadcasts, or continuous signals from

an oscillator, test disc, or electronic instrument.

•When adjusting the sound quality.

•When turning the amplifier on or off.

Other notes

If irregular coloring occurs on your television :

These speakers are designed to be used close to a television, but the

picture may be affected with some televisions and set-up combina-

tions.

If this occurs, turn the television off for about 30 minutes.

The television’s demagnetizing function should correct the problem.

If it persists, move the speakers further away from the television.

You cannot remove the speaker net.

Keep magnetized items away.

Magnetized cards, bank cards, commuter passes, etc., can be dam-

aged if allowed too near speaker magnets. Clocks may also be af-

fected.

Avoid locations such as described below :

•In direct sunlight

•Near heating appliances or other sources of heat

•Where the humidity is high

Maintenance

Clean these units with a soft, clean, dry cloth.

Clean regularly to maintain the polished surface.

•Never use alcohol, paint thinner, or benzine to clean these units.

•Before using chemically treated cloth, read the instructions that came

with the cloth carefully.

Specifications

SB-FS702 / SB-PC702

Type 2 way 2 speaker system Bass-reflex type

Speaker (s) Woofer: 6.5 cm cone type x 1

Fullrange: 6.5 cm cone type x 1

Impedance 6 Ω

Input power 200 W (Music), 100 W (DIN)

Sound pressure level 82 dB/W (1.0 m)

Crossover frequency 7 kHz

Frequency range 100 Hz – 25 kHz (at –16 dB)

125 Hz – 22 kHz (at –10 dB)

Dimensions (W x H x D)

SB-FS702 135 x 295 x 145 mm (with the stand)

SB-PC702 250 x 140 x 145 mm (with the stand)

Mass 1.55 kg

SB-FS802 / SB-PC802

Type 1 way 1 speaker system Bass-reflex type

Speaker (s) Fullrange: 6.5 cm cone type x 1

Impedance 6 Ω

Input power 80 W (Music), 40 W (DIN)

Sound pressure level 79 dB/W (1.0 m)

Frequency range 110 Hz – 25 kHz (at –16 dB)

130 Hz – 22 kHz (at –10 dB)

Dimensions (W x H x D)

SB-FS802 110 x 226 x 132 mm (with the stand)

SB-PC802 180 x 139 x 132 mm (with the stand)

Mass 0.93 kg

SB-WA55 / SB-WA54

SPEAKER SECTION

Type 1 way 1 speaker system Bass-reflex type

Speaker (s) Woofer: 17 cm cone type x 1

Impedance 6 Ω

Input power 200 W (Music), 100 W (DIN)

Sound pressure level 80 dB/W (1.0 m)

Frequency range (with amp) 32 – 300 Hz (at –16 dB)

38 – 240 Hz (at –10 dB)

AMPLIFIER SECTION

Output power 100 W (6 Ω) (THD 0.9%)

Input sensitivity / Input Impedance 300 mV/33 kΩ (RCA jack)

Phase switching

SB-WA55 NORMAL/REVERSE

Low pass filter SB-WA55 50 – 200 Hz Variable

SB-WA54 200 Hz Fixed

GENERAL

Power supply

For the United Kingdom, Australia and New Zealand

AC 230 – 240 V, 50 Hz

For others AC 220 – 240 V, 50/60 Hz

Power consumption 168 W

Dimensions (W x H x D)

SB-WA54 / SB-WA55 For Australia and New Zealand

162 x 457 x 420 mm

SB-WA55 For others 162 x 457 x 434 mm

Mass SB-WA55 10.8 kg

SB-WA54 10.6 kg

Specifications are subject to change without notice.

Mass and dimensions are approximate.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic SBTP10EB Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info