Bedienungsanleitung Panasonic sc ak 250 (Seite 17 von 20) (Englisch)

159964

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

RQT8043

RQTV0196

LANG - 5 LANG - 4 FRANÇAIS DANSK DEUTSCH

Troubleshooting guide

Before requesting service, make the checks below. If you can’t ﬁ x the system as described below, or if something

not listed here occurs, refer to the enclosed directory to locate an Authorized Service Center convenient to you or

contact your dealer.

Reference pages are shown as black circled numbers 4.

Common problems

Although the unit is in standby

mode, the display lights up and

changes continuously.

Turn off the demo function. 7

If you set the clock, demo function will be turned off automatically. %

No sound.

Sound stops.

Turn the volume up.

Switch off the unit, determine and correct the cause, then switch the unit on.

Causes include straining of the speakers through excessive volume or power,

and using the unit in a hot environment.

Sound is unﬁ xed, reversed or

comes from one speaker only.

Check the speaker connections. 6

Humming heard during play.

An AC mains lead or ﬂ uorescent light is near the cables. Keep other appliances

and cords away from this unit’s cables.

“ERROR” is displayed.

Incorrect operation performed. Read the instructions and try again.

“– –:– –” appears on the display at

standby mode.

You plugged the AC mains lead in for the ﬁ rst time or there was a power failure

recently.

Set the time. %

“F61” is displayed.

Check and correct the speaker cords connection. 6

If this does not ﬁ x the problem, there is a power supply problem. Consult the

dealer.

Listening to the radio

Noise is heard.

The stereo indicator ﬂ ickers or

doesn’t light.

Sound is distorted.

Use an outdoor antenna. 7

A beat sound is heard.

Turn the TV off or separate it from the unit.

A low hum is heard during AM

broadcast.

Separate the antenna from other cables and cords.

When there is a television set nearby

The picture on the TV disappears

or stripes appear on the screen.

The location and orientation of the antenna are incorrect. If you are using an

indoor antenna, change to an outdoor antenna.

The TV antenna wire is too close to the unit. Separate the antenna wire of the TV

set from the unit.

Using the cassette deck

Poor sound quality.

Clean the heads. ~

Recording is not possible.

If the erasure prevention tabs have been removed, cover the holes with adhesive

tape. #

Playing discs

The display is wrong or play won’t

start.

The disc may be upside down. 5

Wipe the disc.

Replace the disc if it is scratched, warped, or non-standard.

Condensation may have formed inside the unit due to a sudden change in

temperature. Wait for about an hour for it to clear and try again.

The total number of tracks

displayed differs each time the

same disc is inserted.

Unusual sound is heard.

The disc may be scratched, or its data may be defective. Replace the disc.

CD-RW cannot be read.

The disc was incompletely formatted. Use the recording equipment to fully

format the disc before recording.

“VBR–” is displayed instead of the

remaining play time.

The unit cannot display the remaining play time for variable bit rate (VBR) tracks.

RQTV0196-B.indd 17RQTV0196-B.indd 17 2/23/07 4:49:42 PM2/23/07 4:49:42 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic sc ak 250 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Panasonic sc ak 250

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info