Bedienungsanleitung Panasonic sc pt450 (Seite 41 von 48) (Englisch)

371007

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

RQT8043

RQTX0067

REFERENCE

ENGLISHENGLISH

7 Progressive video Page

There is ghosting when

progressive or HDMI output

is on.

• This problem is caused by the editing method or material used on

DVD-Video, but should be corrected if you use interlaced output.

Set “Video Output Mode” in Picture Menu to “480i” or “576i”.

(Alternatively, press and hold [CANCEL] to switch to “480i” or

“576i”.)

• Disable the HDMI AV OUT connection and use other video

connections. Make the settings in the following order:

1 Set “Video Mode” in the “HDMI” tab to “Off”.

2 Set “Video Output Mode” in Picture Menu to “480i” or “576i”.

(Alternatively, press and hold [CANCEL] to switch to “480i” or

“576i”.)

Pictures not in progressive

output.

• Select “480p” or “576p” in “Video Output Mode” in Picture Menu.

• The unit’s SCART (AV) terminal outputs an interlaced signal even if

“PRG” is displayed.

Closed captions not

displayed.

• When HDMI or progressive output is on, closed captions will not be

displayed.

—

7 Unit displays

The display is dark.

• Select “Bright” in “FL Dimmer” in the “Others” tab. 27

“NO PLAY”

• You inserted a disc the unit cannot play; insert one it can.

• You inserted a blank disc.

• You inserted a disc that has not been ﬁ nalized.

—

“NO DISC”

• You have not inserted a disc; insert one.

• You have not inserted the disc correctly; insert it correctly.

—

“F61”

• Check and correct the speaker cable connections.

If this does not ﬁ x the problem, consult the dealer.

“F76”

• There is a power supply problem. Consult the dealer. —

“DVD U11”

• Disc may be dirty. Wipe it clean. 13

“ERROR”

• Incorrect operation performed. Read the instructions and try again. —

“DVD H & &”

“DVD F & & &”

& stands for a number.

• Trouble may have occurred. The numbers following “H” and “F”

depend on the status of the unit. Turn the unit off and then back on.

Alternatively, turn the unit off, disconnect the AC mains lead, and

then reconnect it.

• If the service numbers fail to clear, note the service number and

contact a qualiﬁ ed service person.

—

“U70 &”

& stands for a number.

The actual number following

“U70” will depend on the state

of the main unit.

• The HDMI connection acts unusually.

– The connected equipment is not HDMI-compatible.

– The HDMI cable is too long.

– The HDMI cable is damaged.

—

“REMOTE 1” or “REMOTE 2”

• Match the modes on the main unit and remote control. Depending

on the number being displayed (“1” or “2”), press and hold [ENTER]

and the corresponding numbered button ([1] or [2]) for at least 2

seconds.

RQTX0067-B_new18.indd 41RQTX0067-B_new18.indd 41 3/19/07 5:48:41 PM3/19/07 5:48:41 PM

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic sc pt450 Seite 41

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Panasonic sc pt450

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info