Bedienungsanleitung Panasonic sc zt1 (Seite 27 von 32) (Englisch)

419481

Zoom out

Zoom in

Vorherige Seite

1/32

Nächste Seite

RQT9472

Error messages/Using with headphones/Speciﬁ cations

Troubleshooting and

other information

Error messages

Speciﬁ cations

Using with headphones

Turn down the volume as closest as to the minimum value.

• Plug type: 3.5 mm stereo mini plug

(Headphone) jack

Headphones

(not included)

Note

• Avoid listening for prolonged periods of time to prevent hearing

damage.

• Multi-channel signals are forcibly converged to 2-channel and

output. (2CH MIX)

However, for DVD audio, the front left and right signals are output.

Display Check point/Cause/Countermeasure Pages

CANCEL MUTE FUNCTION

(Scrolling)

• The test signal is not output while muting is on.

Cancel muting for operation.

MUTE (Blinking) • This is always displayed while muting is on. 22

NOT POSSIBLE FOR

THIS INPUT SOURCE (Scrolling)

• You cannot use Dolby Virtual Speaker, SFC and Dolby Pro Logic for dual

sounds.

—

NOT POSSIBLE FOR

THIS PCM SOURCE (Scrolling)

• You cannot use Dolby Virtual Speaker, SFC and Dolby Pro Logic effect with

PCM signals with sampling frequency of over 48 kHz.

NOT POSSIBLE WHEN USING

HEADPHONES (Scrolling)

• You cannot use the sound field effects when using headphones. 27

REMOTE 2

REMOTE 1

•

Set the same remote control code for this main unit and remote control. When “REMOTE 2 ”

is displayed, set the code to “2 ” on the remote control in step 4 of procedure “When other

equipment (mini component system, AV amp, etc.) manufactured by Panasonic operates

with the remote control operations of this system”. When “REMOTE 1 ” is displayed, set the

code to “1 ” on the remote control in step 4 in the same way.

SWITCH OFF POWER

(Scrolling)

•

While “

F70 

” is displayed, all operations but turning ON/OFF operation are not

available. Turn off the system, unplug the AC mains lead, and consult your dealer.

—

TURN OFF DTS FIX MODE

(Scrolling)

• When each input is fixed to DTS (DTS FIX), the sound field effects cannot be

cancelled even if you press [–SETUP, OFF]. Cancel DTS FIX.

U701

• The equipment connected by the HDMI cable is not compatible with this

system’s copyright protection technology.

—

U703

• A problem has occurred with the HDMI connection. Try the following to correct

the problem. Consult your dealer if the error code remains on the display.

– Turn the connected equipment off and on again.

– Disconnect the HDMI cable then reconnect it.

– Do not connect more than 2 sets of equipment to this system’s output.

—

U704

• The system received incompatible video signals through HDMI connection.

Check the settings of the connected equipment.

—

g PRE AMPLIFIER SECTION

Input sensitivity / Input impedance

TV, AUX3 600 mV / 47 kΩ

S/N ratio (IHF A)

BD/DVD, TV, AUX1,

AUX2 (Digital Input) 80 dB (IHF ’66)

Tone controls

BASS 50 Hz, + 6 to – 6 dB

TREBLE 20 kHz, + 6 to – 6 dB

Input/Output terminal

Audio Input

Analogue Input ( TV, AUX3 ) 2

Optical Digital Input ( TV, AUX2 ) 2

Audio Output

Audio Output ( Front L/R, Surround L/R ) 4

Subwoofer Output 1

Headphone Output ( 16 to 64 Ω ) 1

Video/Audio

HDMI Input ( BD/DVD, AUX1 ) 2

HDMI Output ( TV ) 1

This system supports “HDAVI Control 4” function.

g MAIN UNIT GENERAL

Power supply For E, GN AC 220 to 240 V, 50 Hz

For GS AC 110 to 240 V, 50/60 Hz

Power consumption 16 W

In standby condition 0.5 W

In standby condition ( HDMI off mode ) 0.2 W

Dimensions ( W x H x D ) 430 mm x 59 mm x 262 mm

Mass Approx. 2 kg

Operating temperature range 0 °C to 40 °C

Operating humidity range 20 % to 80 % RH (no condensation)

g WIRELESS SECTION

Frequency of the using band 2.4000 GHz to 2.4835 GHz

Number of using channels 3

The reaching distance 15 m

∗1

∗1 It is under the condition as follows.

At same room indoor, there is not an obstacle

between the main unit and the speaker.

And installing a main unit in the position with

equal to or more than 50 cm height.

SPEAKER

g POWER AMPLIFIER SECTION

∗2

RMS output power (at AC 220 to 240 V)

10 % total harmonic distortion

Woofer Speaker ch 60 W (100 Hz, 3 Ω)

Mid High Speaker ch 20 W (1 kHz, 8 Ω)

System Total Power

∗3

160 W (80 W + 80 W)

DIN output power (at AC 220 to 240 V)

1.0 % total harmonic distortion

100 Hz Woofer Speaker ch 40 W (3 Ω)

1 kHz Mid High Speaker ch 15 W (8 Ω)

System Total Power

∗3

110 W (55 W + 55 W)

g SPEAKER SECTION

∗2

2 way 5 speakers system (Bass reflex type)

Woofer part 12 cm cone type

Mid High part 2.4

10 cm flat type

g SPEAKER GENERAL

∗2

Power supply For E, GN AC 220 to 240 V, 50 Hz

For GS AC 110 to 240 V, 50/60 Hz

Power consumption 20 W

Wireless link standby 0.8 W

In standby condition 0.15 W

Dimensions ( W x H x D ) 290 mm × 1231 mm × 290 mm

Mass Approx. 3.9 kg

Operating temperature range 0 °C to 40 °C

Operating humidity range 20 % to 80 % RH (no condensation)

∗2 : per 1 speaker

∗3 : use 2 speakers

Note: 1. Specifications are subject to change

without notice.

2. Total harmonic distortion is measured by

the digital spectrum analyser.

3. Total harmonic distortion is measured by

using AES17 filter.

MAIN UNIT

Power supply differ depending on the symbols (E, GN, GS) indicated on the packaging box.

Panasonic sc zt1 Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Panasonic sc zt1

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info