Bedienungsanleitung Panasonic SCDT110E (Seite 35 von 36) (Englisch)

612797

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

RQT7035

Reference

Sound Page

Picture

Listening to the radio

Unit displays

Television displays

No sound.

Distorted sound.

≥Check the connections.

≥Turn the volume up.

≥Turn muting off.

≥Switch off the unit, determine and correct the cause, then switch the unit on.

Causes include:

–Shorting (bare wires touching) of positive and negative speaker wires.

–Using speakers with an impedance lower than that rated for this unit.

–Straining of the speakers through excessive volume or power.

–Using the unit in a hot environment without proper ventilation.

—

Humming heard during play. ≥An AC mains lead or fluorescent light is near the cables. Keep other appliances and cords away

from this unit’s cables.

—

No sound from the subwoofer. ≥Check that the subwoofer has not been set to “SUB W OFF”. 27

Picture distorted. ≥Some distortion is normal during SEARCH.

≥The screen may be disrupted briefly when you turn on and off the AUDIO ONLY feature.

—

No picture. ≥Check the connection.

≥Make sure the television is on.

≥Ensure the television’s video input setting (e.g., VIDEO 1) is correct.

—

The picture shown on the

television is not normal.

(The sides of the picture are cut

off, the picture is stretched

horizontally or black bands

appear at the top and bottom of

the screen.)

≥Go to Video in the SETUP menus, and change “TV Aspect” to suit your television.

≥Use the television to change the aspect to the correct one.

≥Ensure that the unit is connected directly to the television, and is not connected through a video

cassette recorder.

≥Change the size with the variable zoom function.

—

Picture quality is poor. ≥Check the settings in the GUI screen’s Picture menu. 24

The picture on the television

disappears or stripes appear on

the screen.

≥The location and orientation of the antenna are incorrect. If you are using an indoor antenna,

change to an outdoor antenna.

≥The television antenna wire is too close to the unit. Move the antenna wire of the television from

the unit.

—

Menus not displayed correctly. ≥Change the zoom ratio to “k1.00”.

≥With the GUI screen, change “Subtitle Position” to “0”.

Noise is heard.

“ST” flickers or doesn’t light.

Sound is distorted.

≥Adjust the position of the FM or AM antenna.

≥Use an outdoor antenna.

—

A beat sound is heard. ≥Turn the television off or move it away from the unit. —

A low hum is heard during AM

broadcasts.

≥Move the antenna away from other cables and cords. —

The correct AM frequency can’t

be turned in.

≥Change the frequency step. Press [SELECT] to select “AM”, then press and hold [SELECT] for

10 seconds to change the step to 9 kHz.

—

This unit’s display is off. ≥Press [FL DISPLAY] to turn the display on. 28

“NO PLAY” ≥You inserted a disc the unit cannot play; insert one it can.

≥You inserted a blank DVD-RAM.

—

“NO DISC” ≥You haven’t inserted a disc; insert one.

≥You haven’t inserted the disc correctly; insert it correctly.

—

“F61” ≥Check and correct the speaker cord connections.

If this does not fix the problem, there is a power supply problem. Consult the dealer.

≥Make sure the rear of the unit is well ventilated. The unit’s internal temperature may have

become too hot.

—

“DVD U11” ≥The disc is dirty. Wipe it clean. 5

“ERROR” ≥Incorrect operation performed. Read the instructions and try again. —

“DVD H∑∑”

∑∑ stands for a number.

≥Trouble is likely to have occurred. The number following “H” depends on the status of the unit.

Reset procedure:

Press [Í] to switch the unit to the standby mode and then back to ON. Alternatively, press [Í]

to switch the unit to the standby mode, disconnect the AC mains lead, and then reconnect it.

≥

If the service numbers fail to clear, note the service number and contact a qualified service person.

—

“Cannot display group xx,

picture xx”

≥You are trying to display incompatible pictures. —

No on-screen display. ≥Go to Display in the SETUP menus, and select “On” for “On-Screen Messages”. 29

GUI screen not displayed or

only partially displayed on the

television.

≥Press [3, 4] while the rightmost icon is highlighted to move them down. 22

The disc’s menu is displayed in

a different language.

≥Go to Disc in the SETUP menus, and select the preferred language for “Menus”. 29

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic SCDT110E Seite 35

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info