612825
6
Zoom out
Zoom in
Vorherige Seite
1/20
Nächste Seite
6
RQT9731
Inserting media
*1: Refer to “Playable media” for compatible models. (l 14)
Do not connect an iPad (4th generation) to the
“IPOD_DOCK” connection. This unit might fall over.
Use the “IPOD_PORT” connection.
*2: When using the “IPOD_PORT” connection, do not connect
the following models to this unit:
iPod classic, iPod [4th (colour display), and 5th (video)
generation]
Unexpected behaviour may occur.
*3: Connect using the dedicated USB cable (not supplied).
*4: Insert the USB device directly. Do not use any USB
extension cable.
*5: When using the “IPOD_DOCK” connection:
Be sure to remove the iPod/iPhone/iPad mini from its case.
Make sure that the iPod/iPhone/iPad mini is fully inserted.
If the
iPod/iPhone/iPad mini
is pushed to the left or right,
make sure to check that it is still fully inserted.
Make sure to hold the dock when removing the iPod/
iPhone/iPad mini.
Make sure to close the dock properly after using it.
If not,
The sliding door will not open.
The standby power consumption will increase.
*6: Make sure to tilt the disc so as not to touch the sliding door.
Do not open the sliding door manually.
Make sure that the unit does not fall when inserting or
removing media.
When moving this unit, be sure to remove all media and turn
this unit to standby mode.
Before removing the USB device, select a source other than
“USB”.
Charging starts when an iPod*
2
/iPhone/iPad is
connected to this unit.
During standby mode, charging will not start from the
“IPOD_PORT” connection, however it will start as usual from
the “IPOD_DOCK” connection.
To charge from the “IPOD_PORT” connection, start the
charging before turning this unit to standby mode.
Check the iPod/iPhone/iPad to see if the battery is fully
charged. (Once fully recharged, additional recharging will not
occur.)
If this unit is switched to standby mode
“IPOD CHARGING” is shown on the unit’s display.
PUSH
OPEN
/
CLOSE
iPad
RADIOiPod
/USB
VOLUME
OPEN
/
CLOSE
[SC-HC28DB]
Select “IPOD_DOCK” as the source
Connect using the Lightning connector *1
[SC-HC28DB]
Select “IPOD_PORT” as the source
“USB” is displayed when a compatible USB is inserted.
[SC-HC18]
Select “USB” as the source
Select “CD” as the source
*1, 2, 3
*4
*5
*6
[SC-HC28DB]
[SC-HC28DB] Attach the pad before using this unit.
(l 19)
pad
(supplied)
[SC-HC28DB]
Charging an iPod/iPhone/iPad
SC-HC28_18_EB~RQT9731-B.book 6 ページ 2013年1月3日 木曜日 午後10時17分
6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Panasonic SCHC28DBEB wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info