Bedienungsanleitung Panasonic SCHT670 (Seite 11 von 36) (Englisch)

18696

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

RQT7534

10HBI

Radio operations

L FM frequency settings

You can change the FM step. The step is factory-set to 0.2 MHz, but

you can change it to receive broadcasts allocated 0.1 MHz steps.

1 Press [TUNER/BAND] to select “FM”.

2 Press and hold [SELECTOR] on the main unit.

After a few seconds the display changes to show the current

minimum frequency. Continue to hold the button down. The

minimum frequency changes and the step is changed.

To return to the original step, repeat the above steps.

Note

Any FM/AM frequencies preset in channels will be changed by this

procedure. Preset them again.

Preset tuning

There are two methods of pre-setting stations.

Automatic presetting: All the stations the tuner can receive are

preset.

Manual presetting: You can select the stations to preset and the

order they are preset in.

Up to 15 stations can be set in each, the FM and AM bands.

Automatic presetting

Do the following once

For each, FM and AM.

Tune to the frequency where pre-setting is to begin.

Press and hold [ENTER] until the frequency changes.

¡ Main unit: Press and hold [MEMORY].

The tuner presets all the stations it can receive into the channels in

ascending order.

“SET OK” is displayed when the stations are set. The last

station to be set is then played.

L “ERROR” is displayed

Presetting was unsuccessful. Preset manually.

Manual presetting

1 Tune to the station (A see left: “Manual tuning”).

2 Press [ENTER].

3 While “PGM” is flashing

Press the numbered buttons to select a channel.

Alternatively, press [2 CH 1] then press [ENTER].

The station occupying a channel is erased if another station is

preset in that channel.

Selecting channels

1 Press [TUNER/BAND] to select “FM” or “AM”.

2 Press the numbered buttons or [4 CH 3] to select the

channel.

To select a 2-digit number

Example: To select channel 12, press [X10] A [1] A [2]

Control reference guide

TUNER/BAND

FM MODE

MEMORY

3 TUNING 4

SELECTOR

VOLUME,

DOWN, UP

ENTER

Numbered

buttons

( )

4CH3

/TUNE MODE

VOLUME

–

Manual tuning

1 Press [SELECTOR] to select “FM” or “AM”.

Each time you press the button:

DVD/CD→FM→AM→TV→VCR→AUX

¡ Remote control: Press [TUNER/BAND].

2 Press [ /TUNE MODE] to select “MANUAL”.

Each time you press the button: MANUAL

↔

PRESET

3 Press [3 TUNING] or [TUNING 4] to select the

frequency of the required station.

¡ Remote control: Press [(] or [)].

TUNED: Displayed when a radio station is

tuned.

ST: Displayed when a stereo FM broadcast

is being received.

Press and hold [1 TUNING] or [TUNING 2]

until the frequency starts scrolling to start

automatic tuning. Tuning stops when a

station is found.

4 Adjust the volume.

L If noise is excessive in FM

Press [FM MODE] to display “MONO”.

Press [FM MODE] again to cancel the mode.

The mode is also canceled when you change

the frequency.

The radio

→

RQT7534(2)PC(10-11) 11/2/04, 2:19 pm11

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic SCHT670 Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Panasonic SCHT670

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info