Bedienungsanleitung Panasonic SCHT830V (Seite 11 von 52) (Englisch)

18716

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

RQT7921

∫ Batteries

Do not:

≥mix old and new batteries.

≥use different types at the same time.

≥heat or expose to flame.

≥take apart or short circuit.

≥attempt to recharge alkaline or manganese batteries.

≥use batteries if the covering has been peeled off.

Mishandling of batteries can cause electrolyte leakage which can

damage items the fluid contacts and may cause a fire.

Remove if the remote control is not going to be used for a long period

of time. Store in a cool, dark place.

∫ Use

Aim at the sensor (l 14), avoiding obstacles at a maximum range of 7

m (23 feet) directly in front of the unit.

After plugging the unit into your household AC outlet and pressing [Í]

to turn the unit on for the first time, the unit automatically tunes in all

the channels it can receive and sets the clock.

The unit determines the type of transmission, TV or CATV, as follows:

TV: when there are less than 5 CATV channels.

CATV: when there are 5 or more CATV channels.

Preparation

≥Confirm that the antenna is connected correctly.

≥Turn on the television and select the video input for the VHS.

≥Press [VHS] to put the remote control in VHS mode.

Press [Í] to turn on the unit.

Plug-in Auto Tuning starts and the unit puts the stations it can receive

into channels (l 37, Channel range).

The unit starts auto clock setting when finished, then displays the time.

[Note]

If auto tuning stops partway (by changing the source, turning the unit

off, or due to a power failure).

1 Disconnect the AC power supply cord on the main unit and then

reconnect it.

2 Turn on the main unit.

To cancel partway

Press [MENU].

∫To start Plug-in Auto Tuning again (after relocation, for

example)

Preparation

≥Press [Í] to turn on the unit.

≥Make sure there is no video cassette tape loaded in the unit.

≥Press [DVD/VHS] to select “VHS” as the source.

1 Press and hold [W CH] and [X CH] on the main unit simultaneously

for 3 seconds until the channel changes to “2”.

2 Disconnect the AC power supply cord on the main unit and then

reconnect it.

3 Turn on the main unit. Plug-in Auto Tuning restarts.

∫To set the channels manually (l 37).

∫If the unit couldn’t set the clock automatically

The MANUAL CLOCK SET screen appears. Set the time manually

(l 36).

VOLUME

123

DISC

NAVI

SKIP

SLOW/SEARCH

ENTER

DIRECT

NAVIGATOR

TOP MENU

RETURN

STATUS/

FUNCTIONS

FM/AMDVD/VHS

DVD TV

VHS

TUNER

PICTURE MODE

SETUP

OPEN/CLOSE/EJECT

JET REW

ENTER

PLAY

LIST

INPUT SELECTOR

DVD/VHS

VHS

S10

POWER

OPEN/CLOSE

EJECT

DISC CHECK

/REW FF/

STOP PLAY

DOWN UP

PHONES

VOLUME

STOP

DEMO

PLAY

H.BASS

REC

STEP6

The remote control

Remote control

Batteries

R6/LR6, AA, UM-3

≥Insert so the poles (i and

j) match those in the

remote control.

≥Do not use rechargeable

type batteries.

Antenna system and channel captions all revert to the default

values when you perform the procedure above. Reset the timer

recording settings. (If necessary reset the clock first. l 36,

CLOCK SET)

STEP7

Plug-in Auto Tuning

AUTO CHANNEL SET

PROCEEDING

END :MENU

Disappears 2

RQT7921-P_ENG.book 11 ページ２００５年２月４日　金曜日　午後４時５８分

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic SCHT830V Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info