618351
13
Zoom out
Zoom in
Vorherige Seite
1/28
Nächste Seite
VQT2R75
13
Checking speaker output
Checking the subwoofer volume with the test signal
Output the test signal. ( above steps 1 to 3)
1. Press [SPEAKER LEVEL] to adjust the subwoofer.
2. Press [SPEAKER LEVEL +, –] to adjust the volume of subwoofer.
The front speakers cannot be adjusted with this operation.
The test signal is output from the subwoofer during
adjustment. Then, the test signal is output again in above
order approx. 2 seconds after adjustment.
Adjustment range:
SW: OFF, MIN, 1 to 15, MAX
Stop the test signal after adjustment. (
above step 4)
Note
After the above adjustment, each speaker volume of sound modes is adjusted at the same time.
To confirm the subwoofer volume, press [SPEAKER LEVEL].
Checking audio output with a test signal
Note
Check connections when the speaker does
not output the test signal. (
page 5)
Point the remote control at the signal sensor ( page 6) on the control panel of this system.
To turn on the system
Press.
1
2
3
4
To stop the test signal
Press.
To output the test signal
Press.
The test signal is output from one speaker at a
time for approx. 2 seconds in the following order.
Speaker display
L : Front left,
R : Front right,
SW : Subwoofer
TEST L TEST R
TEST SW
To confirm the audio output from speakers
Press.
Set the volume to the normal level and confirm
the test signal can be heard.
Adjustment range: 0 (Min) to 100 (Max)
Connection
Home Theater connections / Checking speaker output
Connecting STB, etc. with HDMI terminal
TV STB etc.
Digital audio
out (optical)
HDMI
output
HDMI
input
A
B
Connect STB, etc. to the HDMI 2 input terminal
(AUX 1) on this system. (
page 12)
Note
If all HDMI input terminals on this system are being
used, make the connection on the left.
If the connected TV is VIERA Link “HDAVI Control”
compatible, when you make the setting for “Switching
the input automatically to STB, etc.” on page 20 after
connection, you can automatically switch this system’s
input by switching the input source of TV (VIERA) to
STB, etc.
AOptical fibre cable (not supplied)
BHDMI cable (not supplied)
Amplifier
Connect to HDMI input terminals other than
the one connected on page 12.
13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Panasonic SCHTX500 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info