Bedienungsanleitung Panasonic SCPM10 (Seite 22 von 24) (Englisch)

618366

Zoom out

Zoom in

Vorherige Seite

1/24

Nächste Seite

RQT6682

Listening operations

Troubleshooting guide

Before requesting service, make the below checks. If you can’t fix the system as described below, or if something not listed here

occurs, refer to the enclosed directory to locate an Authorized Service Center convenient to you or contact your dealer.

Reference pages are shown as black circled numbers .

Common Problems

No sound.

Sounds unfixed, reversed or

come from one speaker only.

Humming heard during play.

Turn the volume up.

The speaker cords may be shorted. Turn the unit off, check and correct the

connections and turn the unit on.

Check the speaker connections.

An AC mains lead or fluorescent light is near the cables. Keep other appliances and

leads away from this unit’s cables.

If possible in your area, turn the AC mains lead’s plug or connector over to reverse the

lead’s polarity.

“ERROR” is displayed.

“- -:- -” appears on the display.

“F76” is displayed.

Incorrect operation performed. Read the instructions and try again.

You plugged the AC mains lead in for the first time or there was a power failure

recently.

Set the time.

Check and correct the speaker cord connections.

If this does not fix the problem, there is a power supply problem. Consult the dealer.

Noise is heard.

The stereo indicator flickers

or doesn’t light.

Sound is distorted.

A beat sound is heard.

A low hum is heard during

AM broadcast.

An AM broadcast station

cannot be picked up clearly.

Use an outdoor antenna.

Turn the TV off or separate it from the unit.

Separate the antenna from other cables and cords.

Frequency step is set to 10 kHz. Change the frequency step to 9 kHz.

Listening to the radio

The picture on the TV

disappears or stripes appear

on the screen.

The location and orientation of the antenna are incorrect. If you are using an indoor

antenna, change to an outdoor antenna.

The TV antenna wire is too close to the unit. Separate the antenna wire of the TV set

from the unit.

When there is a television set nearby

Poor quality sound.

Recording is not possible.

Clean the heads.

If the erasure prevention tabs have been removed, cover the holes with adhesive tape.

Using the cassette deck

The display is wrong or play

won’t start.

Only one track from the CD is

recorded.

The disc may be upside down.

Wipe the disc.

Replace the disc if it is scratched, warped, or nonstandard.

Condensation may have formed inside the unit due to a sudden change in

temperature. Wait about an hour for it to clear and try again.

Press [CD REC MODE] on the remote control to cancel one track edit recording and

to select the required mode (ALL-REC or OFF).

Playing discs

Remote control doesn’t work. Check the batteries are inserted correctly. 5

Replace the batteries if they are worn.

The remote control

Reference

RQT6682(11-24)NEW.P65 3/24/05, 9:22 AM22

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic SCPM10 Seite 22

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Panasonic SCPM10

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info