Bedienungsanleitung Panasonic SCVK91D (Seite 24 von 40) (Englisch)

618694

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

Radio operations

RQT7700

Manual tuning

1 Press [TUNER/AUX] (main unit: [BAND, TUNER]) to

select “FM” or “AM”.

The unit comes on.

Every time you press the button:

FM →→ AM AUX

2 Press [(] or [)] (main unit: [g, REW/

4] or

[f,

3/FF]) to select the frequency.

Press and hold [(] or [)] (main unit: [g, REW/4] or

[f, 3/FF]) until the frequency starts scrolling to start automatic

tuning. Tuning stops when a station is found.

“TUNED” is displayed when a radio station is tuned.

“ST” is displayed when a stereo FM broadcast is being received.

L If noise is excessive in FM

Press [PLAY MODE] to display “MONO”.

Monaural sound is selected and noise reduces when reception is

weak.

Press [PLAY MODE] again to cancel the mode.

“MONO” is also canceled if the frequency is changed.

The radio

L AM allocation setting (main unit only)

For Saudi Arabia, Kuwait, the Middle East, South Africa and Southeast Asia

The step is factory-set to 9 kHz, but you can change it to receive

broadcasts allocated to 10 kHz steps.

1. Select “FM”.

2. Press and hold [BAND, TUNER].

After a few seconds the display changes to show the current

minimum frequency. Continue to hold the button down. The minimum

frequency changes and the step is changed.

To return to the original step, repeat the above steps.

Note

After changing the “allocation” setting, the frequencies you previously

preset in the memory will be cleared. Preset them again.

Preset tuning

There are two methods of pre-setting stations.

Automatic presetting :All the stations the tuner can receive are

preset.

Manual presetting :You can select the stations to preset and

the order they are preset in.

Up to 15 stations each can be set in the FM and AM bands.

Preparation:

Press [TUNER/AUX] (main unit: [BAND, TUNER]) to select “FM” or

“AM”.

Automatic presetting

Do the following once each for FM and AM.

Preparation: Tune to the frequency where pre-setting is to begin.

Press and hold [PROGRAM] until the frequency

changes.

The tuner presets all the stations it can receive into the channels in

ascending order.

• “SET OK” is displayed when the stations are set. The last station

to be set is then played.

“ERROR” is displayed

Presetting was unsuccessful. Preset manually.

Manual presetting

Pre-set the stations one at a time.

1 Tune to the station (A see left).

2 Press [PROGRAM].

3 While “PGM” is flashing on the display

Press the numbered buttons to select a channel.

Alternatively, press [g, 4] or [f, 3 ] (main unit:

[g,REW/4] or [f, 3 /FF]) then press [PROGRAM].

The station occupying a channel is erased if another station is

preset in that channel.

Selecting channels

1 Press [TUNER/AUX] (main unit: [BAND, TUNER] to

select “FM” or “AM”.

2 Press the numbered buttons or [g,

4] or [f,

to select the channel.

SKIP

PLAY MODE

TUNER/AUX

Numbered

buttons

BAND

TUNER

PROGRAM

REW/,

, /FF

RQT7700(24-26)2 5/14/04, 9:02 AM24

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic SCVK91D Seite 24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Panasonic SCVK91D

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info