Problem Actions
Sound
Problem Actions
No sound is produced
Other
Sound level is low
or sound is distorted
Unable to receive
signals with a
high-performance
aerial
Sound is unusual
TV goes into
"Standby mode"
An error message
appears
DVB HDMI
•
Due to the digital reception technologies involved, quality of the DTV signals may be relatively low in
some cases, despite good reception of analogue programmes.
•
Is "Sound Mute" active? (p. 7)
•
Is the volume set to the minimum?
•
Set the sound setting of the connected equipment
to "2ch L.PCM".
•
Check the "HDMI input" setting in the Sound menu.
(p. 16)
•
If digital sound connection has a problem, select
analogue sound connection. (p. 34)
•
Sound signal reception may be deteriorated.
•
Set "MPX" (p. 16) in the Sound menu to "Mono".
(Analogue only)
•
The sleep function is activated.
•
The TV enters "Standby mode" about 30 min.
after broadcasting ends.
•
Follow the message's instructions.
•
If the problem persists, contact the authorized
Service Centre.
An error message
appears
•
Contact the authorized Service Centre.
FAQs
•
Licence / Specifi cations
•
Frequently Asked Questions
•
Install an aerial individually for the TV and VCR
(or use a splitter).
TV
VCR
(Individual aerial)
(Individual aerial)
Aerial
Input
terminal
Splitter
Aerial Output
Aerial Input
Aerial Output
Specifi cations
Note
•
Design and Specifi cations are subject to change without notice. Weight and Dimensions shown are approximate.
•
This equipment complies with the EMC standards listed below.
EN55013, EN61000-3-2, EN61000-3-3, EN55020.
TH-37PD60EH TH-42PD60EH
Power Source
AC 220-240 V, 50 / 60 Hz
Power
Consumption
Average use 215 W 247 W
Standby condition
0.3 W (Without Tuner Lock On)
20 W (With Tuner Lock On)
Plasma Display
panel
Drive method AC type
Aspect Ratio 16:9
Contrast Ratio Max 10000:1
Visible screen size
94 cm 106 cm
818 mm (W) × 461 mm (H) ×
939 mm (diagonal)
920 mm (W) × 518 mm (H) ×
1,056 mm (diagonal)
No. of pixels 408,960 (852 (W) × 480 (H)) [2,556 × 480 dots]
Sound
Speaker
12 cm × 6 cm × 2 pcs, 8
Ω
Audio Output 20 W (10 W + 10 W), 10% THD
Receiving Systems /
Band name
PAL B, G, H, I, SECAM B, G, SECAM L / L’
VHF E2 - E12 VHF H1 - H2 (ITALY)
VHF A - H (ITALY) UHF E21 - E69
CATV (S01 - S05) CATV S1 - S10 (M1 - M10)
CATV S11 - S20 (U1 - U10) CATV S21 - S41 (Hyperband)
PAL D, K, SECAM D, K
VHF R1 - R2 VHF R3 - R5
VHF R6 - R12 UHF E21 - E69
PAL 525/60 : Playback of NTSC tape from some PAL Video recorders (VCR).
DVB : Digital terrestrial services via VHF / UHF aerial input.
M.NTSC : Playback from M.NTSC Video recorders (VCR).
NTSC (AV input only) : Playback from NTSC Video recorders (VCR).
•
TV signals may not be received in some areas.
Aerial - Rear VHF / UHF
Operating Conditions Temperature : 0 °C - 40 °C
Connection
Terminals
AV1 (Scart terminal) 21 Pin terminal (Audio/Video in, Audio/Video out, RGB in)
AV2 (Scart terminal) 21 Pin terminal (Audio/Video in, Audio/Video out, S-Video in, Q-Link)
AV3 (Scart terminal) 21 Pin terminal (Audio/Video in, Audio/Video out, RGB in, S-Video in, Q-Link)
Others
COMPONENT
Y 1.0 V[p-p] (including synchronization)
P
B, PR ±0.35 V[p-p]
HDMI TYPE A Connector
AUDIO L - R RCA PIN Type × 2 0.5 V[rms]
Output AUDIO L - R RCA PIN Type × 2 0.5 V[rms] (high impedance)
Dimensions ( W × H × D )
968 mm × 641 mm × 97 mm (TV Set only)
968 mm × 704 mm × 320 mm (With Pedestal)
1,068 mm × 701 mm × 97 mm (TV Set only)
1,068 mm × 764 mm × 320 mm (With Pedestal)
Weight
25.0 k
Net (TV Set only)
27.0 k Net (With Pedestal)
29.0 k Net (TV Set only)
31.0 k Net (With Pedestal)
Licence
Trademark Credits
•
DVB is a trademark of the DVB Digital Video Broadcasting Project (1991 to 1996).
•
HDMI, the HDMI Logo and High-Defi nition Multimedia Interface are trademarks or registered trademarks of
HDMI Licensing LLC.
•
HDAVI Control
TM
is a trademark of Matsushita Electric Industrial Co., Ltd.
Trade Mark of the DVB Digital Video Broadcasting Project (1991 to 1996)
TH-37PD60EH Declaration of Conformity No 4207, 7 June 2006
TH-42PD60EH Declaration of Conformity No 4206, 7 June 2006
"Control with HDMI"
function does not work
•
Switch the TV on again with the equipment on.
•
Set “Control with HDMI” to “Off”, then set to “On” again.
(p. 27)
