149172
31
Zoom out
Zoom in
Vorherige Seite
1/40
Nächste Seite
STR
TV/AV
SET UP
31
Your new TV is supplied with programme position 0’ set to receive an RF signal from your VCR, although a Scart c onnection is
preferable if the VCR is so equipped.
However, if for some reason yo ur VCR is tuned to a different RF channel then you will not receive any picture or so und from your VCR
on programme position ‘0’ of the TV. It will be necessary to either adjust the RF c hannel of your VCR (some VCR’s allow adjustment o f
their RF channel via their remote c ontrol unit) or to adjust the tuning of the TV’s programme position ‘0’ or both until it receives the RF
output channel of your VCR.
It is intended that this advice is used in conjunction with the instruction books for your additional equipment.
Use the AV1 Scart terminal for a VCR.
Use the AV2S Scart terminal fo r an S-- Video VCR.
Use the AV2S Scart terminal for a Q-- Link,
NEXT VIEWLINK or compatible VCR.
To tune your TV to the VCR
Switch on the VCR, insert and play a
pre -- recorded tape with known content
Open the Setup menu
Move to Tuning menu
Access Tuning menu
Move to Manual tuning
Access Manual tuning
Select programme position ‘0 VCR
Start searching for the VCR playback
of the known content tape
When the VCR playback is found,
press STR to store
Press the TV/AV button to exit
See below for installation of VCR and
Satellite
Receiver
Notes :
D If picture patterning occurs on programme position ‘0’ it
may be necessary to adjust the RF output channel o f
the VCR, refer to the VCR instruction book.
D If a Satellite Receiver and a VCR are going to be used
with RF cable connections it is important to avoid both
units being set on the same channel.
Refer to the Satellite Receiver and VCR instruction
books for pr ecise tuning information.
VCR AND SATELLITE RECEIVER INSTALLATION
Setup menu
Teletext FASTEXT
Off timer Off
Tuning menu Access
TV/AV
Select
Access
Exit
Manual tuning
21 68
VCR
CH32
Return --
Programme
down/up
Search
down/up
Exit
TV/AV
VCR
’STR’ Button Store
31

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Panasonic tx 28 pl 1 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info