Bedienungsanleitung Panasonic TX-P50XT50 (Seite 7 von 54) (Englisch)

502194

Zoom out

Zoom in

Vorherige Seite

1/54

Nächste Seite

FCC and IC STATEMENT

This equipment has been tested and found to comply with the limits for an Other Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the Panasonic Service Center or an experienced radio/TV technician for help.

FCC Caution:

To assure continued compliance, follow the attached installation instructions and use only shielded interface cables

when connecting to peripheral devices. Any changes or modifications not expressly approved by Panasonic Corp. of

North America could void the user’s authority to operate this device.

FCC and Industry Canada (IC) RF Exposure Warning:

• This TV is equipped with one transmitter interface for insertion of only approved transmitters:

Wistron NeWeb USB Bluetooth Adapter with FCC ID: NKR-DBUBP207.

• The transmitter interface must not be used with other wireless transmitters, unless specifically recommended when

they become available. Other third-party wireless transmitters have not been RF exposure evaluated for use with

this TV and may not comply with FCC and IC RF exposure requirements.

• The transmitter complies with FCC and IC radiation exposure limits set forth for an uncontrolled environment

for mobile use with minimum 20 cm (8 inches) spacing requirement between transmitters and all person’s body

(excluding extremities of hands, wrist and feet) during wireless modes of operation.

Responsible Party: Panasonic Corporation of North America

One Panasonic Way, Secaucus, NJ 07094

Contact Source: Panasonic Consumer Marketing Company of North America

1-877-95-VIERA (958-4372)

email:

consumerproducts@panasonic.com

This device complies with Part 15 of the FCC Rules and all applicable IC RSS standards.

Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

■About wireless LAN adapter (Optional Accessory)

●

Wireless LAN adapter and Access point need to be obtained separately.

For the latest information on applicable wireless LAN adapters, check the following website:

http://Panasonic.com/NetConnect

●

Check that the Access point supports WPS*.

(If it does not support WPS, “Password” of the Access point is required when configuring settings.)

●

Follow the instructions on the Access point setup screen and configure the appropriate security settings.

For more details on setting of Access point, please refer to operating manual for the Access point.

●

We recommend using 11n (5 GHz) for the wireless system between the wireless LAN adapter and Access point.

Communication is also possible with 11a, 11b, and 11g (2.4 GHz), but the communication speed may be slower.

●

If the wireless system of the Access point is changed, devices that could connect by wireless LAN may no longer be

able to connect.

●

When Online Movies, DLNA, or other device is using the network, do not disconnect the wireless LAN adapter.

●

Data transmitted and received over radio waves may be intercepted and monitored.

●

Keep the TV away from the following devices as much as possible:

Wireless LAN, microwaves, and other devices that use 2.4 GHz and 5 GHz signals. Otherwise, the TV failures such

as malfunction may occur due to the radio wave interference.

●

When noises occur due to the static electricity, etc., the TV might stop operating for the protection of the devices. In

this case, turn the TV Off with power On / Off switch, then turn it On again.

* WPS: Wi-Fi Protected Setup

tc_p42_50_XT50_eng_0637.indb 7tc_p42_50_XT50_eng_0637.indb 7 2012/01/20 10:18:552012/01/20 10:18:55

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Panasonic TX-P50XT50 Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Panasonic TX-P50XT50

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info