Bedienungsanleitung Paradyne FrameSaver NP 110 (Seite 3 von 175) (Englisch)

458602

Zoom out

Zoom in

Vorherige Seite

1/175

Nächste Seite

IMPORTANT SAFETY INSTRUCTIONS

When using your FrameSaver NP 110 equipment, basic safety precautions should always be fol-

lowed to reduce the risk of fire, electric shock and injury to persons, including the following:

1. Read and understand all instructions.

2. Follow all warnings and instructions marked on the product.

3. Unplug this product from the wall outlet before cleaning. Do not use liquid cleaners or aerosol

cleaners. Use a damp cloth for cleaning.

4. Do not use this product near water, for example, near any sink or tub, or where the floor is wet.

5. Do not place this product on an unstable cart, stand or table. The product may fall, causing

serious damage to the product.

6. Slots and openings in the cabinet and the back or bottom are provided for ventilation, to

protect it from overheating; these openings must not be blocked or covered. The openings

should never be blocked by placing the product on a carpeted or other similar soft surface.

This product should never be placed near or over a radiator or heat register. This product

should not be placed in a built-in installation unless proper ventilation is provided.

7. This product should be operated only from the type of power source indicated on the marking

label.

8. Do not allow anything to rest on the power cord. Do not locate this product where the cord will

be abused by persons walking on it.

9. Do not overload wall outlets and extension cords as this can result in the risk of fire or electric

shock.

10. Never push objects of any kind into this product through cabinet slots, as they may touch

dangerous voltage points or short out parts that could result in a risk of fire or electric shock.

Never spill liquid of any kind on the product.

11. To reduce the risk of electric shock, do not disassemble this product, but contact Paradyne

Corporation if repair or warranty work is required. Opening or removing covers may expose

you to dangerous voltages or other risks. Incorrect reassembly can cause electric shock when

the appliance is subsequently used.

12. Unplug this product from the wall outlet and refer servicing to qualified service personnel

under the following conditions:

a) When the power supply cord or plug is damaged or frayed.

b) If liquid has been spilled into the product.

c) If the product has been exposed to rain or water.

d) If the product does not operate normally by following the operating instructions. Adjust

only those controls that are covered by the operating instructions because improper

adjustment of other controls may result in damage and will often require extensive work

by a qualified technician to restore the product to normal operation.

e) If the product has been dropped or the cabinet has been damaged.

f) If the product exhibits a distinct change in performance.

SAVE THESE INSTRUCTIONS

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Paradyne FrameSaver NP 110 Seite 3

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info