Bedienungsanleitung Parkside IAN 280248 PHET 15 A1 (Seite 16 von 60) (Deutsch, Englisch, Holländisch, Französisch, Portugiesisch, Spanisch)

745938

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

PHET 15 A1

│

13 ■

5. Service

a) Have your power tool serviced by a qualiﬁed

repair person using only identical replace-

ment parts. This will ensure that the safety of

the power tool is maintained.

Appliance-speciﬁc safety instructions

for electric staple guns

■ Always check that the power tool contains

staples. Careless handling of the electric staple

gun can lead to unexpected ejection of staples,

which could cause injuries.

■ Never aim the power tool at yourself or

other people in the vicinity. Unintended trig-

gering will cause a staple to be shot out, which

can lead to injuries.

■ Do not activate the power tool until it is

pressed ﬁrmly against the workpiece. If the

power tool is not in contact with the workpiece,

the staple can rebound oﬀ the fastening point.

■ Disconnect the power tool from the mains

or battery if a staple becomes jammed in

the power tool. If the electric staple gun is

connected to a power source, it could be unin-

tentionally activated while removing a jammed

staple.

■ Be careful when removing a jammed staple.

The system may be live and the staple could be

forcefully ejected while you are attempting to

unblock the jam.

■ Never use this electric staple gun for

fastening electrical cables. It is not suitable

for the installation of electrical lines, can dam-

age the insulation of electrical cables and thus

cause electrical shocks and increase the risk of

ﬁre.

Supplementary notes

WARNING! RISK OF INJURY!

■ Never aim the appliance towards yourself or

other people or animals.

Ensure that no other people or animals are

on the other side of the workpiece or in the

immediate vicinity.

■ PROTECT YOUR EYES! Wear safety goggles.

This also applies to people who are carrying

out support and holding work during operation.

■ Secure the workpiece! A workpiece securely

held by a clamping device or vice is much safer

than one held in your hand.

■ Always guide the power cord away to the rear

of the appliance.

Original accessories/auxiliary

equipment

■ Only use the accessories and additional

equipment which are speciﬁed in the

operating instructions and compatible

with the appliance.

Operation

Filling the magazine

WARNING! RISK OF INJURY!

■ Switch the appliance oﬀ and remove the

power plug before starting any work on the

appliance.

♦ Turn the appliance around.

♦ Press the release

together (see Fig. A).

♦ Pull the magazine

backwards (see Fig. A).

♦ Fill the magazine shaft

with staples or nails

(see Fig. B).

NOTE

► Nails can only be inserted into the magazine

shaft

from the left – as shown.

♦ After ﬁlling, push the release

into the maga-

zine as far as the stop until it clicks into place.

NOTE

► Use the ﬁll level indicators

, to see

whether the magazine contains staples or

nails.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Parkside IAN 280248 PHET 15 A1 Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info