Bedienungsanleitung Parkside PABK 60 A1 - IAN 96759 (Seite 28 von 34) (Deutsch, Englisch, Holländisch)

595418

Zoom out

Zoom in

Vorherige Seite

1/34

Nächste Seite

28 GB

General safety instructions … / Before initial use / Preparations for use

General safety instructions for compressed air tools

Maintain the device carefully. Check that mov-

ing device parts are working properly and move

freely. Check for any parts that are broken or

damaged enough to detrimentally aﬀect the

functioning of the device. Have damaged parts

repaired before you use the device. Many ac-

cidents have their origins in poorly maintained

devices.

Switch oﬀ the device oﬀ when it is not in use.

Always wear personal protective

device and safety glasses. Wearing

personal protective devices such as

dust mask, non-slip safety shoes, safety helmet

or ear protectors, depending on the type of

compressed air tool and its application, reduces

the risk of injuries.

Check the connections and supply lines. All

maintenance units, couplings and hoses must be

equipped to meet the pressure and air amounts

speciﬁed in the device speciﬁc values. Pressure

that is too low inﬂuences the functioning of the

device; pressure that is too high can cause

damage to property and personal injury.

Protect hoses from kinks, constrictions, solvents

and sharp edges. Keep hoses away from heat,

oil and rotating parts.

Make sure that the hose clamps are always

tightly fastened. If the hose clamps are not

tightly fastened or are damaged, the air could

escape uncontrollably.

Replace damaged hoses immediately. A dam-

aged supply line may result in the air hose

whipping about and may result in injuries.

If the power cable of the device is damaged, it

has to be replaced by the manufacturer or its

service department or a similarly qualiﬁed per-

son in order to avoid hazards.

Do not use the device when tired or under the

inﬂuence of drugs, alcohol or medications. One

moment of carelessness when using the device

may result in serious injuries.

Do not directly inhale the exhaust air. Keep eyes

away from exhaust air. Exhaust air from the

compressed air device may contain water, oil,

metal particles or contamination from inside the

compressor. This may result in injury to health.

BE CAREFUL WHEN

SETTING DOWN THE DEVICE! Always put

down the device so it does not come into contact

with the trigger. This could potentially result in

accidental activation of the device, which again

could result in hazards.

Only use suitable accessories. These may be

purchased from the manufacturer. Using non-

OEM accessories may result in hazards.

Only use ﬁltered and regulated compressed

air. Dust, caustic vapours and / or moisture may

damage the motor of a compressed air tool.

The hose must be designed for pres-

sures of at least 8.6bar or 125PSI,

but at least 150 % of the maximum

pressure generated in the system.

The tool and supply line must be

equipped with a hose coupling to

completely remove pressure when

disconnecting the coupling hose.

Do not modify this device in any way without

the manufacturer‘s approval.

Only use the compressed air device with the

speciﬁed pressure (max. 0.32 MPa / approx.

3 bar).

Disconnect the compressed air device from the

air supply after each use and when not in use.

Do not use the compressed air device if it leaks

or is in need of repair.

Never connect the compressed air device to an

air hose with pressure exceeding 7bar.

Keep your working area clean and well lit. Un-

tidy or poorly lit working areas can lead to ac-

cidents. Working under proper conditions will

allow you better control of the device, particu-

larly under unforeseen circumstances.

Only have the device repaired

by qualiﬁed specialist personnel using OEM

spare parts. This will ensure that your device

remains safe to use.

Keep children and other individuals away from

the device during use. Distractions can cause

you to lose control of the device.

Wear suitable clothing. Do not wear loose cloth-

ing or jewellery. Keep your hair, clothing and

gloves clear of moving parts. Loose clothing,

jewellery or long hair can become trapped in

moving parts.

96759_par_Airbrush_Set_Content_DE_AT_NL.indd 28 28.04.14 09:11

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Parkside PABK 60 A1 - IAN 96759 Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Parkside PABK 60 A1 - IAN 96759

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info