Check that it is properly secure by pulling
the tool.
For removal of bits (a), pull back the locking
sleeve (14) and hold it firmly.
Remove the bit (a) and let go of the locking
sleeve.
8.8 Torque Setting (Fig. 1/Item 13)
Caution:
Only adjust the torque when the appliance is at
a standstill.
The cordless screwdriver is fitted with a
mechanical torque selector.
The torque for each particular screw size is
adjustable at the torque selector (13). The
required torque is dependent upon several
factors:
the type and hardness of the material to be
worked with.
the type and length of the screws used.
the physical burden placed on the screw
connection.
When the torque is reached, this is indicated by
the clutch being released.
8.9 Screws
It is advisable to use self-centering screws (e.g.
Torx, Philips head screws) as these will enable
you to work safely and reliably. Always make
sure that the bit used is of the same size and
shape as the screw.
8.10 Screwdriver overloaded
If the screwdriver is overloaded, the automatic
safety switch turns the device off. After a few
seconds the screwdriver can be used again.
9. Cleaning, maintenance and
ordering of spare parts
Caution:
Always pull out the mains power plug before
starting any cleaning work.
9.1 Cleaning
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the appliance with a clean
cloth or blast it with compressed air at low
pressure.
We recommend cleaning the appliance
immediately after every use.
Clean the appliance regularly with a damp
cloth and some soft soap. Do not use
cleaning agents or solvents; these may be
aggressive to the plastic parts in the
appliance. Ensure that no water can get into
the interior of the tool.
9.2 Maintenance
There are no other parts inside the equipment
which require additional maintenance.
9.3 Ordering replacement parts:
Please provide the following information on all
orders for spare parts:
Model/type of the equipment
Article number of the equipment
ID number of the appliance
For our latest prices and information please go
to www.isc-gmbh.info
GB/
MT
54
