722849
27
Zoom out
Zoom in
Vorherige Seite
1/141
Nächste Seite
GB
IE
 23
PAHE 20-Li A1
Cut length: approx. 200 mm
Blade: 8” Oregon 080NDEA318
Saw chain: Oregon 91P033X
Use only the following battery to operate the
cordless tool: PAP 20 A3
Type: LITHIUM ION
Rated voltage: 20 V
(direct current)
Capacity: 4000 mAh / 80 Wh
Cells: 10
Use only the following high-speed battery
charger to charge the cordless tool:
PLG 20 A2
INPUT:
Rated voltage: 230–240 V
~
, 50Hz
(alternating current)
Power consumption: 85 W
Fuse (internal): 3.15 A
T3.15A
OUTPUT:
Rated voltage: 21.5 V
(direct current)
Charging current: 3.5 A
Charging time: approx. 80 min
Protection class: II /
(double shielded)
Noise and vibration data:
Measured values for noise determined in accord-
ance with EN ISO 22868. The A-rated noise level
of the power tool is typically as follows:
Sound pressure level: L
pA
= 88 dB (A)
Uncertainty: K
pA
= 3 dB
Sound power level: L
WA
= 106 dB (A)
Uncertainty: K
WA
= 3 dB
Wear ear protection!
Vibration values (vector total of three directions)
determined in accordance with EN ISO 22867:
Vibration: < 2.5 m/s
2
Uncertainty K = 1.5 m/s
2
WARNING!
Also reduce the risk due to vibrations, e.g.
the risk of Raynaud's phenomenon, by taking
frequent breaks and rubbing your hands
together!
NOTE
The sound pressure level must be reduced to
such an extent that the operator’s health is
not adversely affected depending on the use
and the activities to be carried out. The sound
pressure level at the workplace can exceed
80 dB (A). In this case, sound insulation
measures are required for the operator
(e.g. wearing ear protectors).
The vibration level specified in these instruc-
tions has been measured in accordance with
a standardised measuring procedure speci-
fied and can be used to make equipment
comparisons. The specified vibration emission
value can also be used to make an initial
exposure estimate.
WARNING!
The vibration level varies in accordance with
the use of the power tool and may be higher
than the value specified in these instructions
in some cases. There is a risk of underestima-
tion of the vibration load if the power tool is
used regularly in this manner. Try to keep the
vibration loads as low as possible. Meas-
ures to reduce the vibration load are, e.g.
wearing gloves and limiting the working time.
In this case all states of operation must be
included (e.g. times when the power tool is
switched off and times where the power tool
is switched on but running without load).
Explanation of symbols on the appliance:
Read the operating instructions
and safety advice before initial
operation!
Wear protective gloves!
Wear safety shoes!
Wear ear protection!
27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Parkside PAHE 20-Li A1 - IAN 315261 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info