796077
13
Zoom out
Zoom in
Vorherige Seite
1/132
Nächste Seite
PDSSAP 20-Li B2
8 GBIE
Inserting/removing the battery pack
Inserting the battery pack
Set the rotation direction switch2 to the middle
position (lock). Snap the battery pack8 into
the handle.
Removing the battery pack
Press the release button9 and remove the
battery pack8.
Checking the battery charge level
Press the battery charge level button w to
check the charge level of the battery. The
status/remaining charge will be shown on
the battery display LED q as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Fitting the belt clip
Loosen the fixing screw 3a using a standard
Phillips screwdriver (not supplied).
Hold the corresponding hole of the belt clip 3
over that of the screw thread.
Tighten the fixing screw 3a .
Switching on/off
Switching on
Press and hold the ON/OFF switch 7 to start
the tool.
The LED work light 4 lights up when the ON/
OFF switch7 is pressed lightly or fully.
This provides illumination of the work area in
poor lighting conditions.
Switching off
Release the ON/OFF switch 7 to switch off the
appliance.
Setting/preselecting the rotation
speed/tightening torque
Press the torque preselection button6 to select
the required torque incrementally. The selected
torque is shown on the torque display5.
Pressing the ON/OFF switch7 lightly yields a
low speed. Increasing the pressure increases
the speed/tightening torque.
The tightening torque depends on the selected
speed/torque preselection and impact duration.
NOTE
When tightening wheel nuts, however, the
smallest torque setting must be selected to
avoid over-tightening.
The integrated motor brake ensures rapid
stoppage.
ATTENTION!
The tightening torque actually attained must
always be checked with a torque wrench!
13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Parkside PDSSAP 20-Li B2 - IAN 364886 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info