762951
24
Zoom out
Zoom in
Vorherige Seite
1/110
Nächste Seite
24
GB IE
The device must only be con-
nected to a mains socket via
a RCD (Residual Current De-
vice) with a rated leakage cur-
rent of not more than 30mA.
Fuse: at least 13ampere.
Before each use, check the
equipment, cable and plug
for damage.
If the power cable for this
equipment is damaged, it
must be replaced by the
manufacturer, a customer ser-
vice agent of the same or a
similarly qualied person in
order to prevent hazards.
Do not pull the plug from the
socket by the cable. Protect
the cable from heat, oil and
sharp edges.
Do not carry or x the equip-
ment by the cable.
Unsuitable extension cables
can be dangerous. If an ex-
tension cable is used it must
be suitable for outdoor use,
and be routed above the
ground. We recommend us-
ing a cable drum that holds
the socket at least 60mm
above the ground.
Check the cable for damage.
Before any work on the
equipment, during work
breaks and in the case of
non-use, remove the plug
from the socket.
The cross-section of the pow-
er supply cable must not be
less than 2x2,5mm².
Wear sturdy footwear to pro-
tect against electric shock.
To protect against electric
shock, operate the equipment
only in an upright position.
Always shut off the power
switch when leaving the ma-
chine unattended.
Start-up
In keeping with current regulations a
pressure cleaner must never be oper-
ated off the drinking water mains
supply without a controllable back-
ow preventer. A suitable backow
preventer in conformity with
EN 12729 type BA must be used.
Water that has passed through a backow
preventer is classied as undrinkable.
A backow preventer is available in spe-
cialist shops.
A system separator (check valve) prevents
the backow of water and detergent into
the drinking water pipeline.
Use a commercially available 1/2”
garden hose, at least 5m long, for wa-
ter supply.
Do not exceed a length of 30m.
Use the device on a domestic water
connection with an output of at least
450l/h.
Setting up
1. Pull the curved handle (2) up as far as
it will go.
2. Connect the high-pressure tting (jet
gun) (29) to the jet gun (14). Ensure
that the hose runs to the front, so as not
to impede the handle (2).
3. Connect the feed hose to the water
supply and allow water to escape from
the other end of the feed hose with no
bubbles, in order to expel the air from
the feed hose. Switch off the water tap.
4. Connect the feed hose with the help of
the quick connector for garden hose
adapter (22) with the water connection
24

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

parkside-phd-170-b2---ian-346400

Suche zurücksetzen

  • Welchen Wasseranschluss hat dieser Kärcher? 1/2 oder 3/4 Eingereicht am 11-4-2023 18:37

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Parkside PHD 170 B2 - IAN 346400 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Parkside PHD 170 B2 - IAN 346400

Parkside PHD 170 B2 - IAN 346400 Bedienungsanleitung - Deutsch - 22 seiten

Parkside PHD 170 B2 - IAN 346400 Bedienungsanleitung - Holländisch - 19 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info