12
GB/IE/
CY
2. Safety information on the laser
Important:
Laser radiation
Do not look into the beam
Laser class 2
Protect yourself and your environment from
accidents by taking the appropriate
precautionary measures.
Do not look directly into the laser beam with
the naked eye.
Never look directly into the laser path.
Never direct the laser beam at reflecting
surfaces, persons or animals. Even a low
output laser beam can inflict injury on the
eye.
Caution: It is vital to follow the work
procedures described in these instructions.
Using the equipment in any other way may
result in hazardous exposure to laser
radiation.
Never open laser module.
When the laser is not going to be used for
an extended period of time, the batteries
should be removed.
Never use an optical instrument (for
example magnifying glass) to view the laser
beam.
Check the laser for damage on a regular
basis and always before use. To protect
yourself against injury, never use the
equipment if it is damaged.
Defective lasers have to be repaired by a
customer service workshop.
3. Safety information on the batteries
Never recharge the batteries. Danger of
explosion.
Keep batteries out of the reach of children.
Do not throw batteries into the fire, short-
circuit or take them apart.
If necessary clean the contacts on the
batteries and equipment before inserting the
batteries.
Remove flat batteries immediately from the
equipment. Risk of leakage!
Always replace all batteries in one go. Only
use new batteries of the same make.
Avoid contact with skin, eyes and mucous
membranes. If you come into contact with
battery acid, rinse the affected pars at once
with plenty of clear water and seek
immediate medical assistance.
Do not expose batteries to extreme
conditions, e.g. do not place on heaters or in
direct sunshine. Increased risk of leakage.
4. Maintenance and service
The following conditions can have an
influence on noise impact on the operator:
- Type of saw blade (e.g. saw blades
designed to reduce noise development)
- Material of the workpiece
- The force with which the workpiece is
pushed against the saw blade
Faults on the machine or its guards, safety
devices and blade must be reported to the
person in charge as soon as they are
discovered.
5. Safe operation
Use a suitable blade for the material you
wish to saw.
Never use the drag, crosscut and miter saw
to cut any materials other than those
specified by the manufacturer.
Use only the transport devices to move the
equipment. Never use the guards for
handling or moving the equipment.
Use the saw only if it is in perfect condition
and properly maintained and only if the
guards are correctly positioned.
When cutting miters, make sure that the
device for swiveling the arm is fastened
securely.
The floor around the machine must be level,
clean and free of loose particles, such as
chips and cutting residues.
The operator must receive proper training in
the use, adjustment and operation of the
machine.
Only use properly sharpened saw blades.
