Bedienungsanleitung Peg Perego Aria Shopper (Seite 14 von 56) (Alle Sprachen)

626093

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

- 14 -

EN_English

WARNING

IMPORTANT: read these instructions carefully and

keep them for future use. The child’s safety could be

at risk if these instructions are not followed.

_ This product was designed for the transport of 1 child

in the seat.

_ Do not use this product for a number of occupants

greater than that intended by the manufacturer.

_ This item is approved for children from 6 months up

to a weight of 15 kg in the seat.

_ This seat unit is not suitable for children under 6

months.

_ This product is designed to be used with Ganciomatic

Peg-Perego products: "Primo Viaggio SL" (group 0+)

car seat, suitable for children from birth to 13 kg.

_ When used in combination with car seat (0+ group ),

this vehicle does not replace a cot or a bed.

Should your child need to sleep, then it should be

placed in a suitable pram body, cot or bed.

_ WARNING Check that the pram body or seat unit or

car seat attachment devices are correctly engaged

before use.

Check that the Peg Perego Ganciomatic product are

correctly fixed to the item.

_ WARNING The assembly and preparation of the

product must be carried out by an adult.

_ Do not use this product if there are parts missing or

signs of breakage.

_ WARNING Always use the restraint system. Always

use the five point harness. Always use the harness

crotch strap in combination with the waist strap.

_ WARNING Never leave your child unattended.

_ Always apply the brake when stationary.

_ WARNING Ensure that all the locking devices are

engaged before use.

_ WARNING To avoid injury ensure that your child is

kept away when unfolding and folding this product.

_ WARNING This product is not a toy. Do not let your

child play with this product

_ Do not insert fingers into the mechanisms.

_ Be careful not to hurt the child when adjusting the

mechanisms (handlebar, backrest … ).

_ Any weights hanging on the handlebar or

handles could make the item unstable; follow the

manufacturer’s instructions regards the maximum

loads transportable.

_ The front bar (if present) is not designed to support

the child’s weight. It is not designed to keep the child

in the seat and does not substitute for the waist belt.

_ Do not load the baskets over 5Kg. Do not put weight

in the cup holder (if present) in excess of those

indicated on the cup holders themselves and never

hot drinks. Do not put loads of more than 0.2 Kg in

the hood pockets (if present).

_ Do not use the product near to stairs or steps, heat

sources, naked flames or dangerous objects within

reach of the child.

_ Only replacement parts supplied or recommended by

the manufacturer/distributor shall be used.

_ WARNING Don't use the rain cover (if present)

on a product without a hood or parasol that can

hold it. Always use the rain cover only under adult

supervision. Don't use the rain cover indoors and

check to ensure the child is not to warm; do not

park the vehicle close to heat sources and keep well

away from the lighted cigarettes. Ensure that the rain

cover is not interfering with any moving parts of the

carriage/stroller. Always remove the rain cover before

folding your carriage/stroller.

_ WARNING: This product is not suitable for running or

skating.

_ Always apply the brake when loading or unloading

children.

_ WARNING Do not add any mattress are not approved

by the manufacturer.

_ Do not use accessories which are not approved by

the manufacturer.

INSTRUCTIONS

1 OPENING: (fig_a) to open the stroller, release the two

connectors simultaneously, lift the handle upwards

sharply (fig_b) and then push it down again until it

snaps into place (fig_c).

If the front clips do not fasten properly, push down on

the seat until they click into place.

Once the stroller is open, use the magnets to attach

the fabric on the sides of the seat to the armrests.

2 FITTING THE REAR WHEELS: To mount the rear wheel

unit, press button 1 all the way down (fig_a) while

pressing on the wheels until they click into place

(fig_b).

3 FITTING THE FRONT WHEELS: To mount the front

wheels, lower the lever (fig_a) and click the wheels

into place (fig_b).

4 BASKET: slide the basket under the seat in the

direction as shown and slip the front loops over the

two hooks on the frame (arrow 1). Slip the basket’s

rear slit over the handle of the support tube (arrow 2)

and slide the basket over the support tube (arrow 3),

fastening the two buttons at the back and the two on

the side (arrow 4). Finally fasten the two loops at the

back onto the buttons on the frame (arrow 5).

5 FITTING THE FRONT BAR: Attach the front bar as

shown in the figure.

6 HOOD: To attach the hood, insert the tabs into the

notches (fig_a) and button the hood to the rear of the

backrest (fig_b).

7 The hood can be rotated into several positions (fig_a).

To remove the hood, press the side buttons while

lifting the hood off (fig_b).

8 BRAKE: Press down on the brake lever situated on the

rear wheel unit to set the brake on the stroller. Lift the

lever to release the brake. Always set the brake when

the stroller is at a standstill.

9 FIVE POINT SAFETY HARNESS: To fasten it, push the

two waist strap buckles (with the shoulder straps

attached – arrow_a) into the leg divider until they click

into place (arrow_b). To unfasten it, press the round

button in the centre of the buckle (arrow_c) and pull

the waist straps out (arrow_d).

10 To tighten the waist strap, pull on both sides in the

direction of the arrow (arrow_a). To loosen it, move it

in the opposite direction.

11 To adjust the height, slip the belts through the eyelet

in the fabric and position them in the most suitable

eyelet.

12 ADJUSTING THE BACKREST: to lower the backrest press

the clip (fig_a) and the backrest will move down to the

desired position. To raise the backrest, press the clip

and lift the backrest to the desired height.(fig_b).

13 SWIVELLING WHEELS: Lower the lever (fig_a) to allow

the front wheels to swivel. Lift the lever for fixed

wheels (fig_b).

14 FRONT BAR: the front bar can be opened to make it

easier for an older child to get in and out. To open on

one side only, press one of the two buttons (1 or 2)

and rotate it upwards (fig_a). To remove it, press both

buttons (1 and 2) and simultaneously pull it upwards

(fig_b).

15 REMOVING THE WHEELS: To remove the rear wheels,

press the button (fig_a) and at the same time push

the wheels down until they come off (fig_b).

16 CLOSING: before closing the stoller, close the hood

if it is fitted (fig_a). To close the stroller, lift the two

levers on the handle (fig_a) and rotate the handle

forwards until it clicks into position (fig_b).

17 Push the backrest and the hood towards the stroller

Peg Perego Aria Shopper Seite 14

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info