Bedienungsanleitung Pelgrim GVW 592 (Seite 72 von 79) (Deutsch, Englisch, Holländisch, Französisch)

78021

Zoom out

Zoom in

Vorherige Seite

1/79

Nächste Seite

If you decide to turn back to the use of

standard detergent system we advise

that you:

1. Fill up the dispensers for salt and rinse aid

again.

2. Adjust the water hardness setting to the

highest setting and perform 1 normal

washing programme without loading any

dishes.

3. Adjust the water hardness setting ac-

cording to the hardness of the water in

your area.

4. Adjust the rinse aid dosage.

Select and start a washing programme

Select the washing programme with

the door slightly opened. The start of

the programme will occur only after

the closure of the door. Until then it

is possible to modify the settings.

1. Check that the baskets have been loaded

correctly and that the spray arms are free

to rotate.

2. Check that the water tap is opened.

3. Press the on/off button. The appliance

must be in setting mode.

4. Press the programme selection/cancel

button until the light corresponding to the

required washing programme comes on

(see 'Washing programmes' chart).

Close the appliance door, the pro-

gramme starts automatically.

Setting and starting the programme with

delay start

The start of the washing programme will

be delayed by 3 hours.

1. Select a washing programme.

2. Press the delay start button. The corre-

sponding indicator light comes on.

3. Close the appliance door. The count-

down starts automatically.

Opening the door will interrupt the

countdown. Once the door is closed the

countdown will continue from the point

at which it was interrupted.

4. Once the countdown has elapsed the

washing programme will start automati-

cally.

Cancel a delay start in progress

1. Open the appliance door.

2. Press the delay start button. The corre-

sponding indicator light goes off.

3. Close the door. The washing programme

will start automatically.

Warning! Interrupt or cancel a

washing programme in progress

ONLY if it's absolutely necessary.

Attention! Hot steam may escape

when the door is opened. Open the

door carefully.

Interrupt a washing programme in

progress

Open the appliance door; the programme will

stop. Close the door; the programme will

start from the point at which it was interrup-

ted.

Cancel a washing programme in

progress

• Open the appliance door; press the pro-

gramme selection/cancel button for about

3 seconds, until the light of the running

programme goes off and the end of pro-

gramme indicator light flashes. The wash-

ing programme has been cancelled and

the appliance is now in setting mode.

• If a new washing programme is to be se-

lected, check that there is detergent in the

detergent dispenser.

End of the washing programme

• The appliance will automatically stop and

an audible signal informs you of the end of

the washing programme.

• Open the appliance door.

• The end of programme indicator light is on.

• The indicator light of the programme just

ended remains on.

1. Switch off the appliance by pressing the

on/off button.

2. Leave the appliance door ajar and wait a

few minutes before removing the dishes;

in this way they will be cooler and the dry-

ing will be improved.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pelgrim GVW 592 Seite 72

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info