31
30
USE
■ The correct quantity of rinse-aid per
washing cycle is adjustable.
Turn the knob (B) in the container to the
desired setting (C). The amount of rinse-aid
is in proportion to the numbers on the knob.
– Increase the amount (choose a higher
number):
Washed kitchenware is dull or flecked as
a result of dried drops of water.
– Reduce the amount (choose a lower
number):
Washed kitchenware is sticky or has
whitish streaks.
Remark:
As standard, the rinse-aid reservoir is set to
an average dose.
Detergent
fig. 6a
fig. 6b
In the door, next to the rinsing agent reservoir,
there is also a reservoir for the detergent
(see fig. 6a).
■ Open the lid of the reservoir by pressing
button (A).
■ Fill the reservoir (B) with approx. 25
grammes of detergent.
Follow the detergent manufacturer's
guidelines.
■ If you select the "intensive" programme,
please take the following steps:
Fill the reservoir (B) with approximately
20 grammes of detergent, and fill the pre-
wash detergent reservoir (C) with
approximately 10 grammes of detergent.
Close the lid. Depending on the model
concerned, the reservoir (C) may be on the
top of the lid in the form of a recessed area
(see fig. 6b).
Remark:
The container lid is opened automatically
during the washing cycle in order to add the
detergent to the water. If washing tablets are
used – in a holder attached to the cutlery
basket – the container should be closed.
USE
Adjustment of the water-softener
The dishwashing machine is equipped with a
device which can be adjusted to the degree of
hardness of the tap water. After having
opened the door, you will find the device
located in the interior on the right, and it can
be adjusted with the aid of a coin (see fig. 4).
This model can be set to one of five settings.
Before adjusting the water-softener, please
consult the table below and set the number of
the chosen level (1, 2, ...) to the reference
symbol.
fig. 4
Model with 5 settings
water hardness settings
German French
degrees degrees
0 - 9 °dH 0 - 15 °dF setting 1
(no salt)
10 - 15 °dH 0 - 25 °dF setting 1
16 - 23 °dH 26 - 40 °dF setting 2
24 - 34 °dH 41 - 60 °dF setting 3
35 - 46 °dH 61 - 80 °dF setting 4
47 - 58 °dH 81 - 100 °dF setting 5
Contact the Water Company to make enquiries
about the hardness of the mains water.
Rinse-aid
fig. 5
■ Open the rinsing agent reservoir (see fig. 5)
on the inside of the door, next to the
detergent reservoir.
The means of operation will depend on the
type of dishwasher: the containers all work
on the basis of the same principle.
■ Unscrew the lid of the rinse-aid reservoir in
an anti-clockwise direction.
■ Pour rinse-aid into the container and then
close it again.
The container has a capacity of 140 cc.
■ Every now and again check the level of the
rinse-aid.
The level gauge (A) is located to the upper
left of the lid.
Reservoir empty:
!
.
Reservoir full:
c
.
A
B
C
