39
38
■ Transfer the markings of the drill holes on
the template onto the door.
■ If the door panel is made of solid wood,
predrill the holes with a 2 mm drill (12 mm
deep).
Note
Allow for possible differences in the thickness
of the panel (milled hollows or bevelled edges).
■ Fit the attachment material to the door, as
indicated on the template. Be careful of the
position of the flat sides for the upper
attachment pins: these must point
outwards.
■ Attach the panel to the door of the
dishwasher by pressing the upper pins (A)
into the slots of the plastic section.
Hang the lower hooks in the slots on the
left and right at the front.
■ Fasten the bottom hooks from the front with
M5 screws (B).
Disassembling door panel
■ Remove the screws (B).
■ Pull the pins in the left and right side of the
panel outwards with the aid of the plastic
tool provided (C).
Adjusting the spring tension (see fig. 13)
fig. 13
■ As standard setting, the door is adjusted to
the lowest spring tension.
■ Increase the tension of the spring by
turning the two adjusting screws (A) in a
clockwise direction with a screwdriver.
The tension of the spring is correct if the
door is in a state of equilibrium when open.
MOUNTING
■ The dishwasher may be connected either
to a cold-water tap or to a hot-water tap
(maximum 60 °C).
If you connect the dishwasher to a hot-
water tap, the washing time will be
reduced by about twenty minutes.
However, the dishwasher will wash less
efficiently.
■ Do not drill holes in the door or walls. The
dishwasher could be damaged beyond
repair.
Adjusting the height
■ The height of the dishwasher may be
adjusted from 820 to 870 mm by means of
the adjustable feet. Before you do this,
measure the height of the recess.
– It is advisable to place the appliance on a
so-called dishwasher platform.
Ask your kitchen dealer for information.
Mounting
Installing door panel (see fig. 12a/12b)
fig. 12a
fig. 12b
■ Place the template on the inside of the door
panel.
The top of the template is the top of the
door panel.
The top of the template must be placed
level with the top of the door panel.
Centre the template on the right and left
sides with the aid of the measuring marks.
INSTALLATION
A
B
C
A
