Bedienungsanleitung Pelgrim gwa 810 (Seite 19 von 23) (Deutsch, Englisch, Holländisch, Französisch)

133008

Zoom out

Zoom in

Vorherige Seite

1/23

Nächste Seite

3534

2.1 What you need to take into account

Attention! Make sure the appliance is installed by an authorised installer (see

"Installation" chapter). Do not connect the appliance to the ﬂow network before

completing the installation.

• Connect the appliance in accordance with the applicable regulations in your area.

• We advise you to wear protective work gloves during the installation of the exhaust

hood due to possible sharp edges.

• The appliance has been manufactured in accordance with the latest safety standards.

However we do advise that mentally handicapped, disabled or retarded individuals do

not use this appliance without the proper supervision of a competent person. The same

applies to children.

• Never use the exhaust hood when the grease ﬁlters have not been properly installed!

• Do not lean against the exhaust hood.

• Make sure there is sufﬁcient circulation when you use the exhaust hood on a gas

cooker.

• The exhaust exit must never be connected to a smoke duct which is also used for other

heating appliances.

• Never ﬂambé under the exhaust hood and always clean the ﬁlters on time. Frying needs

to be done under constant supervision to prevent the heated fat from catching ﬁre.

• The exhaust hood needs to be cleaned regularly (at least once a month) on the inside

as well as on the outside. When the ﬁlters are insufﬁciently cleaned or replaced, this will

result in a ﬁre hazard.

• If the connection cable becomes damaged, it should be replaced by the manufacturer’s

service department or by a person with equivalent qualiﬁcations, in order to prevent

dangerous situations from arising.

• First disconnect the appliance from the socket when you replace the lights! Only use

identical lamps with the wattage indicated. Only use the exhaust hood with lamps

installed to reduce the risk of electrical shock.

• The ﬁlter grid can be removed by pulling it straight down. Do this by using both hands.

• The ﬁlter grid with grease ﬁlter is becoming hot during operation. Wait a minimum of

30 minutes after cooking before cleaning it.

Appliance description

1 - Moisture collector

2 - Grease ﬁlters

3 - Control panel

4 - Lighting

Controls

5 - Lighting switch

6 - Switch for electrical ﬂap or speed regulator fan

Depending on the quantity of moisture you can choose a higher or lower position. Start

the exhaust hood 5 minutes before cooking. Leave the exhaust on after cooking for

another 15 minutes.

When an exhaust hood is connected to a central exhaust circuit you are only able to put

the lights on and off and to open and close the electrical ﬂap.

Apply carbon ﬁlter (only in case of re-circulation)

Place the carbon ﬁlter in the middle on the motor housing cap and turn it to the right one

full turn.

Introduction

When you read this users manual you will be quickly informed of all the options the

appliance offers you. You will be informed of safety measures and maintenance of the

appliance.

Keep this users manual and the installation guide. This will be of use for any user of this

appliance.

1 Equipment description and use

2 Safety

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pelgrim gwa 810 Seite 19

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info