Bedienungsanleitung Pelgrim IDK 641 (Seite 49 von 54) (Deutsch, Englisch, Holländisch, Französisch)

71735

Zoom out

Zoom in

Vorherige Seite

1/54

Nächste Seite

General

In case of faults phone the service

department. See the guarantee certificate or

consult the internet site www.hps.nl.

If you notice a crack on the cooking

surface (no matter how little), switch

off the appliance immediately.

Remove the plug from the socket

or set the switch of the power

supply cable (in the case of a fixed

connection) to zero or turn off the fuse

switch(es) in the meter cupboard.

Phone the service department.

This appliance should only be connected up

by a registered electrical installer!

The electrical connection must comply with

national and local regulations.

Damage caused by incorrect connection,

incorrect use or incorrect building in is not

covered by the guarantee.

FAULTS

Table

If the appliance does not work properly, this does not always mean that it is defective. Try to

deal with the problem yourself first by checking the points mentioned below:

You have observed the following: Possible causes: Solutions:

The display lights up. Normal operation. Do nothing, the display disappears

after 30 seconds.

Only works on one side.

The fuse in the meter cupboard is

defective.

Continuous beep.

The appliance is incorrectly

connected.

Check the electrical connection.

See electrical connection (page

100).

When first used a strange smell

comes from the hob.

New appliance. Warm a pan full of water for 30

minutes on each zone.

The hob does not work and the

displays on the operating panel

remain out.

The appliance is receiving no

power. Defective power supply or

incorrect connection.

Check the fuses and the electrical

master switch.

The hob does not work and an error

code F1, F2, F3 or F4 is displayed.

The electrical circuit works poorly. Contact the Service Department.

The hob does not work, the

information

or is

displayed.

The hob is locked. See chapter on use of child

protection.

The hob switches off during use, 4

dashes are displayed.

Something has boiled over or there

is an object on the operating panel.

Clean the hob or remove the object

and then continue cooking.

A series of small

or F0 is

displayed.

The electronic circuits are warm. See chapter on installation.

Error code F0 Pan is boiled dry or to hot. Let appliance cool down or continu

cooking on a lower setting.

After switching on a cooking

zone, the operating panel display

continues to flicker.

The pan you are using is not suitable

for induction cooking or has a

diameter of less than 12 cm (10 cm

for the 16 cm cooking zone).

See chapter on pans for induction

cooking.

Error code F5 or F6 Appliance overheated due to

insufficient ventilation.

Check the building-in situation or

contact the Service Department.

The pans are noisy during cooking.

Your cooking pan makes a ticking

sound during cooking.

Normal for certain types of pan.

It is caused by the energy being

transmitted from the hob to the pan

Do nothing. There is no danger for

the hob or for your pan.

The ventilator continues to work for

several minutes after the hob has

been switched off.

The electronics are cooling off.

Normal operation.

Nothing.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pelgrim IDK 641 Seite 49

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info