692055
29
Zoom out
Zoom in
Vorherige Seite
1/60
Nächste Seite
EN 15
General
The electrical connection must be carried out ONLY by qualified technicians.
The electrical protection of the electrical connection upstream of the equipment must comply
with the regulations in force.
The aspiration system is composed by two appliances:
Connect the appliances to a permanent connection.
Make sure that the voltage (V) and frequency (Hz) indicated on the serial number plate
located on the appliances correspond to those available at the installation site.
Any change to the electrical installation necessary to install the hood should only be
undertaken by competent person.
The electrical connection of the appliance must follow the diagram, according to the voltage
of the electricity network.
To make a fixed connection to the network, a omnipolar interruption device must be
interposed between the unit and the network. This device must ensure a separation of
contacts, providing a complete disconnection in the category III overvoltage conditions.
After installation, insulated parts and those carrying electricity must be protected from any
possible contact.
CAUTION! If the electrical connection is carried out incorrectly or not meeting the
regulations, it may damage part of the appliance and the warranty will not respond.
CAUTION! Before any intervention, disconnect the appliance from the power mains.
These devices must be connected to an earthed system.
Electrical connection of the induction hob
The connection terminals can be reached after opening the conductors cover.
The plate with all the technical data is located at the bottom of the hob.
Connect the protective cable to the terminal marked with the earth cable symbol.
The connecting cable must pass through the bracket protecting it from accidental strain.
After connecting the appliance, turn on all cooking zones / heaters for approximately three
minutes to make sure they are operating correctly.
Connection cable on the back of the appliance should be led in such way that it does NOT
touch the appliance back wall, as this part will get very hot during operation.
Connection load
L1 (W) L2 (W) L3 (W) Total load hob (W) Total load hood (W)
3700 3700 7400 275
ELECTRICAL CONNECTION
29

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Pelgrim IKR2083 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Pelgrim IKR2083

Pelgrim IKR2083 Zusatzinformation - Deutsch - 28 seiten

Pelgrim IKR2083 Bedienungsanleitung - Deutsch - 52 seiten

Pelgrim IKR2083 Zusatzinformation - Englisch - 28 seiten

Pelgrim IKR2083 Bedienungsanleitung - Englisch - 52 seiten

Pelgrim IKR2083 Zusatzinformation - Holländisch - 28 seiten

Pelgrim IKR2083 Bedienungsanleitung - Holländisch - 52 seiten

Pelgrim IKR2083 Zusatzinformation - Französisch - 28 seiten

Pelgrim IKR2083 Bedienungsanleitung - Französisch - 52 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info