Bedienungsanleitung Pelgrim ISW 850 (Seite 10 von 11) (Deutsch, Englisch, Holländisch, Französisch)

109483

Zoom out

Zoom in

Vorherige Seite

1/11

Nächste Seite

- 11 -

paperwork indicates that the appliance should not be

treated as domestic waste, but should be delivered to a

suitable electric and electronic appliance recycling

collection point.

Follow local guidelines when disposing of waste.

For more information on the treatment, re-use and

recycling of this product, please contact your local

authority, domestic waste collection service or the shop

where the appliance was purchased.

INSTALLATION INSTRUCTIONS

Assembly and electrical connections must be carried

out by specialised personnel.

• Electric Connection

The appliance has been manufactured as a class II,

therefore no earth cable is necessary.

The connection to the mains is carried out as follows:

BROWN = L line

BLUE = N neutral

If not provided, connect a plug for the electrical load

indicated on the description label. Where a plug is

provided, the cooker hood must be installed in order that

the plug is easily accessible.

An omnipolar switch with a minimum aperture of 3mm

between contacts, in line with the electrical load and

local standards, must be placed between the appliance

and the network in the case of direct connection to the

electrical network.

• The minimum distance between the support surfaces of

the cooking pots on the cooker top and the lowest part of

the cooker hood must be at least 65 cm.

If a connection tube composed of two parts is used, the

upper part must be placed outside the lower part.

Do not connect the cooker hood exhaust to the same

conductor used to circulate hot air or for evacuating

fumes from other appliances generated by other than an

electrical source.

Before proceeding with the assembly operations, remove

the anti-grease filter(s) (Fig.2 G) so that the unit is easier

to handle.

In the case of assembly of the appliance in the suction

version prepare the hole for evacuation of the air.

Installation

To properly install the hood, proceed as follows:

1.Fixing the cooker-hood to the lower part of a wall unit

2.Select method of operation (extraction or re-circula-

tion).

Fitting the cooker-hood to the lower part of a wall unit.

The appliance should be embedded into the wall unit or

another support. This process should be carried out by

using 4 screws suitable for the kind of unit following the

instructions for the drilling of the holes as shown in (Fig. 1)

Exhausting Version

With this type of installation the appliance discharges

the vapours externally outside the main wall or an exist-

ing exhaust conductor. A non inflammable Ø 150 mm

mural telescopic tube (acceptable standard) is neces-

sary and should be connected to the flange B supplied

GENERAL

Carefully read the following important information regarding

installation safety and maintenance. Keep this information

booklet accessible for further consultations.

The appliance has been designed for use in the ducting

version (air exhaust to the outside), filtering version (air

circulation on the inside ) or with external motor .

SAFETY PRECAUTION

1. Take care when the cooker hood is operating

simultaneously with an open fireplace or burner that

depend on the air in the environment and are supplied by

other than electrical energy, as the cooker hood removes

the air from the environment which a burner or fireplace

need for combustion. The negative pressure in the

environment must not exceed 4Pa (4x10-5 bar). Provide

adequate ventilation in the environment for a safe

operation of the cooker hood.

Follow the local laws applicable for external air evacuation.

Before connecting the model to the electricity net-

work:

- control the data plate (positioned inside the appliance)

to ascertain that the voltage and power correspond to

the network and the socket is suitable. If in doubt ask a

qualified electrician.

2. WARNING !

In certain circumstances electrical appliances may be

a danger hazard.

A) Do not check the status of the filters while the

cooker hood is operating

B) Do not touch bulbs or adjacent areas, during or

straight after prolonged use of the lighting installation.

C) Flambè cooking is prohibited underneath the cooker

hood

D) Avoid free flame, as it is damaging for the filters

and a fire hazard

E) Constantly check food frying to avoid that the

overheated oil may become a fire hazard

F) Disconnect the electrical plug prior to any

maintenance.

G) This appliance is not intended for use by young

children or infirm persons without supervision

H) Young children should be supervised to ensure they

do not play with the appliance

I) There shall be adequate ventilation of the room when

the rangehood is used at the same time as appliances

burning gas or other fuels

L) There is a risk of fire if cleaning is not carried out in

accordance with the instructions

This appliance conforms to the European Directive EC/

2002/96, Waste Electrical and Electronic Equipment

(WEEE). By making sure that this appliance is disposed

of in a suitable manner, the user is helping to prevent

potential damage to the environment or to public health.

symbol on the product or on the accompanying

ENGLISH

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Pelgrim ISW 850 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info