12
INSTALLATION
■ If the recirculation system is to be applied,
mount the T-piece (C) instead of a duct.
■ Fit the short cylinder to the mounting
bracket (B) and pull the long cylinder to the
top of the canopy hood.
■ Screw the chimney in place from the inside
of the canopy hood (remove filters).
Electrical connection
■ Connect the two lamp connectors to the
motor connector.
■ Connect the connector of the slide box to
the remaining motor connector.
■ Make sure the supply voltage ratings
correspond with those stated on the
appliance data plate.
■ Attention: If you want to make a fixed
connection, ensure that a multi-pole switch
with a distance between contacts of 3 mm
is installed in the supply cable.
■ The appliance must be connected to a
system equipped with earth or ground
plate.
■ Colour of the wires:
- green/yellow = earth
- blue = phase N
- brown = phase L
Mounting the canopy hood above
an island
See fig. 9. Make sure that the ceiling is
suitable for the suspension of the construction
chimney.
■ First determine the position and distance
with regard to the chimney. Make a 140
mm hole in the ceiling for the duct.
■ If the opening for the flex (bottom of the
chimney construction 1) is pointed towards
you, then the control switches will be to
your right.
■ Drill 4 10 mm holes for the plugs and screw
the chimney against the ceiling.
■ Press the 2 flange halves (2) firmly
together, so that the snap connection is
made and then screw the assembled flange
(2) to the canopy hood.
■ Slide the inner cylinder (3) over the
chimney construction up to the ceiling and
fix it with 2 screws (4). Then slide the outer
cylinder (5) on.
■ Fix the canopy hood to the chimney
construction with the 4 M6 screws (6).
■ Make the electrical connection and
observe the flex opening (1).
■ Now fix the outer cylinder (5) to the cooker
hood with 2 screws, this is done from the
inside of the cooker hood.
Technical specifications
Type LSK 950/980/990/990G/991995 SKE 900 SKE 925
Power 230 V - 50 Hz X X X
Nominal capacity W 250 240 290
Motor W 210 210 210
Lighting W 2xhalo 20 2xTL 15 4xhalo 20
